Mitsubishi Electronics HC7800DW user manual Signal menu

Menu operation (continued)

SIGNAL menu

opt. opt.

SIGNAL				SIGNAL
		HORIZ. POSITION	0	USER
		VERT. POSITION	0		CLAMP	1
					POSITION
		FINE SYNC.	0		CLAMP WIDTH	1
		TRACKING	0		VERT. SYNC.	AUTO
		COMPUTER	AUTO		LPF	OFF
	RRGGBB INPUT
		OVER SCAN	100%		SHUTTER(U)	0
		HOLD	ON		SHUTTER(L)	0
		USER	OK		SHUTTER(LS)	0
					SHUTTER(RS)	0

ITEM	SETTING			FUNCTION
HORIZ. POSITION	0	-	999	Use to adjust the horizontal position of the projected image.
VERT. POSITION	0	-	999	Use to adjust the vertical position of the projected image.
FINE SYNC.	0	-	31	Use to eliminate flickering or blur, if it appears, while viewing the projected
				image.
TRACKING	0	-	9999	Use to eliminate vertical wide stripes, if it appears, while viewing the
				projected image.
COMPUTER INPUT	AUTO			The proper setting is automatically selected.
	RGB			Select this option when connecting the projector to high definition video
				equipment having R, G, and B output terminals.
	YCBCR / YPBPR			Select this option when connecting the projector to a DVD player or other
				device having Y, CB, and CR (or Y, PB, and PR) component video output
				terminals.
OVER SCAN	100 - 90%			Use to adjust the display area of the projected image when playing LD and
				DVD discs.
HOLD	OFF / ON			Use to adjust the image when flagging occurs near the top of the screen.
USER	OK
CLAMP POSITION 1 -			255	Use to correct solid white or solid black in the projected image.
CLAMP WIDTH 1 -			63	Use to correct solid black in the projected image.
VERT. SYNC.	AUTO / OFF			Use to adjust the image when its motion doesn’t run smoothly. Select AUTO
				for normal use.
LPF	ON / OFF			Use to select whether or not to enable the LPF.
SHUTTER(U)	0 -		32	Use to display the black bar on the top part of the image.
SHUTTER(L)	0 -		32	Use to display the black bar on the bottom part of the image.
SHUTTER(LS)	0 -		95	Use to display the black bar on the left half of the image.
SHUTTER(RS)	0 -		95	Use to display the black bar on the right half of the image.

•Though horizontal strips may appear on the enlarged projected image, such symptom is not a malfunction.

•When you change the horizontal or vertical position to a large extent, noise may appear.

•The adjustable range of the vertical position varies depending on the type of the input signal. Though the image may stay in the same position even when the setting value is changed, such symptom is not a malfunction.

•If you increase the OVER SCAN setting when viewing video signals, noise may appear on the screen. In this case, decrease the OVER SCAN setting.

•While a 3D signal is being displayed, OVER SCAN is fixed to 100%.

EN-34