Preparing your projector

Mitsubishi Electronics HC7800DW Preparing your projector, What’s included in the box

What’s included in the box

AC power cord*	for US	J2552-0063-03	Remote control
	for EU	J2552-0247-00	User Manual/Quick Start up (English only)
	for UK	J2552-0065-02	Safety Manual/Quick Start up
	for Australia	J2552-0053-00	CD-ROM (with User Manual)
	for South Korea	J2552-0247-00	Battery (2)
Computer cable		J2552-0072-05	Lens cap
Mini DIN 5-pin cable		J2552-0376-00	Lamp replacement attachment
			3D emitter
			Non-slip sheet
			3D emitter securing screw (2)

* One of power cords for the U.S., Europe, U.K., Australia, and South Korea is provided appropriately.

Important:

• The attached power cord is to be used exclusively for this product. Never use it for other products.

Inserting the batteries into the remote control

		1.	Remove the back lid of the remote control.
1	3	2.	Check the polarity (+), (-) of the batteries, and set them
1	3		correctly, inserting their (-) side first.
			• If the battery is inserted from the (+) side first,
			inserting the (-) side is difficult because the coil spring
	2		end hits on the battery side. If the battery is forced in
	2		this way, the outer label of the battery may get ripped
			and it may cause a short-circuit and heating.
		3.	Attach the back lid.
		Important:
		•	Use two size-AA batteries (R6).
		•	Replace the two batteries with new ones when the
			remote control is slow to respond.

Removing the batteries from the remote control

Remove the back lid of the remote control and take out the batteries.

Caution:

•Use of a battery of wrong type may cause explosion.

•Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.

•Dispose of used batteries according to your local regulations.

•Before you dispose of the batteries, insulate them by placing insulation tape on the positive (+) and negative (-) terminals. If you dispose of the batteries together with other conductive objects such as a metal piece, they may short out, resulting in fire or explosion.

•Batteries may explode if misused. Do not recharge, disassemble, or heat the batteries, or put them into fire or water.

•Be sure to handle the batteries according to the instructions.

•Load the batteries with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.

•Keep batteries out of reach of children and pets. If children swallow the battery, see a doctor immediately.

•Remove the batteries, if the remote control is not used for a long time.

•Do not combine a new battery with an old one.

•If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact with your eyes, rinse them with water and then consult your doctor.

•Do not carry or store the batteries together with metallic ballpoint pens, necklaces, coins, or hairpins. Otherwise, they may short out, causing explosion or liquid leakage and resulting in fire or injury.

•Do not store the batteries where they are exposed to direct sunlight or subjected to high temperature and high humidity. High temperature and high humidity may cause corrosion or liquid leakage.

EN-6