Microsoft MN-500 manual My Network Settings

Page 81

My Network Settings

Use this page to record your network settings.

Workgroup or domain name: ______________________________________

Base Station password: __________________________________________

(Default=admin)

Wireless Settings

Record the information used to configure a computer for wireless access to your network here. All computers accessing your network with a wireless connection need to use the same wireless settings.

Wireless network name (SSID): ____________________________________

WEP key or WPA passphrase: ______________________________________

Wireless channel (ad-hoc networks only): ____________________________

Wide Area Network Settings

Complete this section only if your network has a base station (gateway or router). You can obtain this information from your Internet service provider (ISP). Your ISP may not require all of the settings listed below.

Dynamic IP (DHCP) Settings

Complete this section only if your ISP uses a DHCP connection.

Host name: _____________________________________________________

Adapter MAC address: ____________________________________________

Static IP Address Settings

Complete this section only if your ISP has assigned you a specific IP address. Static IP address: ________________________________________________

Subnet mask: ___________________________________________________

IP gateway address: ______________________________________________

Primary DNS server: ______________________________________________

Secondary DNS server: ___________________________________________

PPPoE Settings

Complete this section only if your ISP uses PPPoE.

User name: _____________________________________________________

Password: ______________________________________________________

Service name: ___________________________________________________

Image 81

Contents Page Avertissement Contents View Status View Network Devices Contents Page Introduction About Your Wireless Base StationBase Station Ports, Status Lights, and the Reset Button UPnP Standards and Your Wireless Base StationIntroduction Using the Base Station Stand Resetting the Base StationRestoring Factory Default Settings Placement of Wireless Components About Wireless Radio ConnectionsUnderstanding Wireless Transmission Standards Adjusting the AntennaEthernet Cables About Wired Ethernet ConnectionsWhich Cable Should You Use? Straight-Through Ethernet CableCrossover Ethernet Cable Setup Gather Components, Tools, and Information Typical SetupThis User’s Guide Run the Setup WizardConnect the Base Station Configure the Base Station Test Your NetworkWhat’s Next? To set up the base station wirelessly Setting Up the Base Station WirelesslyCustom setup Base Station Setup Establish the Base Station PasswordOpen the Base Station Management Tool Establish Your Internet Settings Establish Your Wireless Security Settings Establish Your Wireless SettingsConfigure Your Computer Customize Network SettingsTest Your Internet Connection Network activities Using an Internet Connection over a Network Logging on to Your NetworkTo log off and log back on to your network To start the Broadband Network Utility Using the Broadband Network UtilityTo refresh the Network Devices list To remove an inactive device from the Network Devices listUsing Files and Folders over a Network Make your files and folders available to the networkTo share a folder or drive on your computer in Windows XP To share a folder or drive on your computer in Windows Using a Printer over a Network Access shared filesTo access shared files on other computers About Reading E-Mail Messages on a Network Using Other Peripheral Devices over a NetworkPlaying Games on Your Network and on the Internet View Status Monitoring Your NetworkView Network Devices To refresh the network device listUpdating Software, Drivers, and Firmware To upgrade software, drivers, or firmwareMaking Your Network More Secure Help Protect Your Network from Computer VirusesHelp Protect Your Network from Hackers Help Protect Your Network from Unauthorized AccessPage Setup and Hardware Problems TroubleshootingSetup does not recognize my wireless base station If your base station is connected wirelesslyIf your base station is connected with an Ethernet cable Troubleshooting To clone a MAC address Troubleshooting Network and Internet Problems Can’t stay connected to my wireless networkTo disable 802.1x authentication in Windows XP Troubleshooting Page Troubleshooting My network is slow Troubleshooting Page Cant print to a networked printer Printing and File Sharing IssuesPage Troubleshooting Click OK to save the changes To determine which connection type your ISP provides Internet Connection TypeDynamic IP Dhcp Settings General Internet SettingsTo locate your Internet settings Host NameStatic IP Settings To locate your static IP address settings Windows XPTo locate your static IP address settings Windows PPPoE Settings Workgroup NameTo determine your workgroup name in Windows XP or Windows Wireless Network Name Wireless Security SettingsTo determine your workgroup name in Windows Me and Windows Technical Support Options Getting HelpRegulatory Information United States Radio and TV Interference RegulationsCanadian Radiocommunication Regulations Base Station Technical SpecificationsSystem Requirements END-USER License Agreement for Microsoft Software General Provisions Limited Warranty Contrat DE Licence Utilisateur Final Pour Logiciel Microsoft Dispositions Générales Garantie Limitée Page Glossary Page Glossary Page Glossary Page Index Interference Index Typical Setup base station, 9 preparing for My Network Settings