Microsoft G7VP2 manual Jumper JPP ATX Power-On/Off Select, Pins 1 and 2 On ATX Power

Hardware Installation

2.6Jumper Settings for ATX Power-On/Off Select (ATX power supply only)

Jumper JPP

ATX Power-On/Off Select

Jumper JPP is used to select the method of powering-on/off a computer that is using an ATX power supply.

Pins 1 and 2 On (ATX Power)

Uses the power button to

power-on the computer. To power-off the computer, you can either press the power button or execute the Shut Down

command in the Windows® 95/

98 operating system. If you are using the Shut Down command, make sure “Software Power-off” in the Chipset Features Setup of the Award BIOS is set to Enabled. Refer to chapter 3 of this manual for more information.

Pins 2 and 3 On (AC Power)

As long as the AC power is On, the computer will always be in its power-on state and will power-off only when the AC power is Off or disconnected from the computer. The advantage of this setting is when power returns after a power failure, the computer will continue to operate.

Important:

If you wish to use the AC power to power on/off the computer, make sure JP2 pins 1, 2 and 3 is set to Off.

1	1
2	2
3	3
1-2 On: ATX Power	2-3 On: AC Power
(default)

2

21