Microsoft G7VP2 manual Hardware Installation Floppy Disk Drive Controller, IDE Hard Disk Interface

Hardware Installation

2.9.5Floppy Disk Drive Controller

1.Install the 34-pin header connector into the shrouded

floppy disk header (J11) on the system board. The colored edge of the ribbon should be aligned with pin 1 of connector J11.

2. Install the other 34-pin

header connector(s) into the disk drive(s). Align the colored edge of the daisy

chained ribbon cable with

pin 1 of the drive edge connector(s). The end-most connector should be attached to the drive you want to designate as Drive A.

2.9.6IDE Hard Disk Interface

1.If you are connecting two hard drives, install the 40-pin connector of

the IDE cable into the primary shrouded IDE header (connector J10). If you are adding a third or fourth IDE device, install the 40-pin connector of the other IDE cable into the secondary shrouded IDE header (connector J12).

2.Install the other 40-pin header connector(s) into the device with the colored edge of the ribbon cable aligned with pin 1 of the drive edge connector(s).

Note:

Refer to your disk drive user’s manual for information about selecting proper drive switch settings.

2

27