Oregon Scientific JM889N Diagram Instructions, Placement of Unit, Method Instruction Diagram

Batteries

NOTE When using the product for the first time, please note that the batteries have already been installed in the unit. To operate, locate the clear plastic battery tab inside the battery compartment and remove it.

To load the batteries:

Diagram	Instructions
	1. Locate the battery compartment.
	2. Install the batteries by matching the correct
	polarity.Alwaysusethecorrectbatterytype
	(2 UM-3 AA-sized 1.5V batteries).
	Warning: Reversing the polarity may
	damage the product.

NOTE Replace the batteries whenever the weak battery mark ( ) is shown, the display is dim, or the display does not illuminate when the power is on. Replace all the batteries at the same time - it is dangerous to mix old and new batteries.

Contact your local waste disposal authority for instructions on how to dispose of used batteries. Used batteries can be harmful to the environment, and should not be thrown out with household trash.

EN

Placement of Unit

You can either mount the main unit on a wall or make it stand on a flat surface.

Method	Instruction	Diagram
Table	The unit is already equipped with a Table
Stand	Stand. Simply pull out the Table Stand
	and rest the main unit on a flat surface.

Wall	The main unit can be mounted onto a wall
Mount	using a No. 6 screw (3.0mm).
	a) Position and nail the screw into the
	place where you would like to hang
	your main unit.
	b) Leave ample space between the wall
	and the screw head while testing to
	make sure the nail is secure.
	c) Fit the unit’s Wall-Mount Recess Hole
	onto the screw head.

5