JVC DLA-X30, DLA-X90R, DLA-X70R manual Function

3 Operation

Adjustments and settings in the menu (continued)

[5] Function

Use this function to set command communications, remote control codes, OFF timer function, etc. You can also reset the lamp time.

Use the UP/DOWN keys to select an adjustment item. Press the [BACK] key to return to the previous screen.

Trigger	Off
Off Timer	Off
High Altitude Mode	Off
Remote Code	RS-232C
Network
Remote Code	A
Lamp Reset

Items		Explanation, operation, precautions, settings
Trigger		Configures 12V output to an external screen equipped with a trigger function.
		Settings: Off, On(Power), On(Anamo)	[Off]
	Off	No output.
	On (Power)	When turned on, control signals (12V) from the trigger terminal are emitted.
		If you turn off the power, the output of the control signal stops.
		During standby mode, an output will occur if the [OK] button is pressed.
		After cooling, the output stops when you go back to standby.
	On (Anamo)	Control signals (12V) are emitted when the Anamorphic mode is set from "Off” to “A” or
		“B”. If the Anamorphic mode is set to "A" or "B", the operation in this state equals "On
		(Power)".
Off Timer		Sets Off Timer function and its time.
		(*) If there are no operations, the unit powers off automatically.
		(*) It powers off automatically even while projecting an image.
		(*) You will be given a warning 60 seconds before power turns OFF.
		Press the [OK] button while the warning is being displayed to delete the warning display.
		You cannot configure settings to omit warning display.
		Settings: Off, 1 hour, 2 hours, 3 hours, 4 hours	[Off]
	Off	Power is not turned off.
	1 Hour	Power is turned off automatically after 1 hour.
	2 Hours	Power is turned off automatically after 2 hours.
	3 Hours	Power is turned off automatically after 3 hours.
	4 Hours	Power is turned off automatically after 4 hours.
High Altitude Mode		Set to use at low pressure locations (900m above sea level).
		Settings: On, Off	[Off]
	On	Set.
	Off	Do not set.
Communication		Sets the used control terminal. It is not possible to use it at the same time.
Terminal		Settings: RS-232C, LAN	[RS-232C]
	RS-232C	Sets the RS-232C terminal.
	LAN	Sets the LAN terminal.
Network		It is displayed, if the setting of the "Communication terminal” to the submenu "[5-1]
		Network" is set to "LAN".
Remote Code		Use this function to change the projector's remote control code. The projector can be
		operated only with a remote control configured with the same code. To change the remote
		control code itself, press "MENU" and [BACK] together for three seconds or more. All of
		the buttons on the remote control will begin to blink. Two blinks indicate "Change A to B";
		three blinks indicate "Change B to A".
		Settings: A, B	[A]
	A	Set the projector's remote control code to "A".
	B	Set the projector's remote control code to "B".
Lamp Reset		Reset of the lamp use time to "0".

72