Connecting to Various Devices
Connecting the Power Cord
Basic Operations
■Projector’s buttons
The following describes the basic procedure for normal use of the projector.
DLA-M2000LU DLA-M2000LE
After all devices have been finished being connected, connect the supplied power cord. At this time, do not yet turn on the MAIN POWER switch.
STAND BY
LAMP TEMP
STAND BY indicator OPERATE indicator
1. Turning on the Power
Power cord (supplied)
CAUTIONS
To prevent fire and electric shock, observe the following:
1Insert the supplied power cord into the power input terminal of the projector.
2Insert the main plug of the supplied power cord into a suitable wall outlet.
CAUTIONS
• Do not turn on the projector without installing the lens unit |
(optional). Doing so can cause the |
(black one) initially installed to be deformed by heart from |
the |
| OPERATE |
HIDE |
|
| PC |
KEYSTONE | VOLUME |
| VIDEO |
PRESET | MENU |
ESCAPE | ENTER |
OPERATE button
1 Turn on the MAIN POWER switch.
ON [ ❙❙] : The main power turns on and the STAND BY indicator comes on.
Projector’s indicator
STAND BY
OPERATE
2Press the OPERATE button for one second or more.
•The OPERATE indicator lights and the projected screen slowly appears.
Remote control unit | Projector |
STAND BY
OPERATE
OPERATE
Notes
•After the power is turned on, the image may be jumbled for a few seconds, but this is not a malfunction.
•After the indicator comes on, it can take a minute or so for the lamp to warm up and operate consistently.
■Turning off the Power
No.51781
•When you do not use devices, pull out their power cords from wall outlets.
•Do not connect the devices with power cords other than those supplied.
•Do not use mains voltage other than the power voltage indicated.
•Do not scar, damage, or work on the power cords. Also, do not put a heavy object on, heat, or stretch the power cords, otherwise they may be damaged.
•Do not insert or pull out the plugs with a wet hand.
• Since the power requirement of the projector is high, insert |
the power plug directly into a wall outlet. |
• Use the supplied power cord with the ferrite core only. |
• Do not remove the ferrite core from the supplied power |
cord; Otherwise, there may be a possibility that a harmful |
interference occurs. |
■Remote control unit
FREEZE |
| OPERATE |
| HIDE | OPERATE button |
PRESET |
| MENU |
|
| E |
|
| NT |
|
| E |
|
| R |
ESCAPE |
| VIC SELECT |
1Press the OPERATE button for one second or more.
•The STAND BY indicator changes to blinking, and the projector goes into
mode will continue for approximately 120 seconds.
Remote control unit | Projector (Blinking) |
OPERATE | STAND BY |
| OPERATE |
DEUTSH ENGLISH
Removing the Lens Cap
Remove the lens cap before using the projector.
Note
•The lens cap is supplied with the lens unit (optional). It should be attached to the lens when the projector is not used.
•Do not operate the projector with the lens cap attached. Doing so can deform the lens cap because of the heat. A metallic lens cap can get hot and cause injury.
30
PC
+
DIGITALZOOM KEYSTONE VIDEO
–
U T +
SHIFT ZOOM FOCUS
D W –
+ +
QUICK
SHUTER ALIGN. VOLUME
––
Note
•The OPERATE button will not work for approximately 1 minute from when the
2Turn off the MAIN POWER switch after the
STAND BY indicator changes to steady on.
OFF [‡] :The MAIN POWER switch turns off and the STAND BY indicator goes off.
Projector
STAND BY
OPERATE
CAUTION
•Do not turn off the MAIN POWER switch during
31