1 Installation
1.2.2Manual Installation
Requirements
JavaScript must be enabled (this is the default setting) on your browser. For more information, consult the help of your web browser.
Procedure
Proceed as follows:
1Connect the Thomson Gateway to your broadband service.
2Power on the Thomson Gateway.
3Connect your computer to the Thomson Gateway.
4Configure the Thomson Gateway.
This is described in the sections below.
Connect the Thomson Gateway to your broadband service
Proceed as follows:
1Take the DSL cable with the grey connectors. This cable is included in your box.
2Plug one end of the cable in the grey DSL port on the back of your Thomson Gateway.
3If you are:
Using a splitter, plug the other end of the cable into the Modem/ADSL out put of your splitter. Not using a splitter, plug the other end of the cable directly in the wall outlet.
For more information about splitters, see “Filters and splitters” on page 4.
Power on the Thomson Gateway
Proceed as follows:
1Connect the power cord to the Thomson Gateway’s power port.
2Plug the other end into an electrical outlet.
3Push the power button to turn on the Thomson Gateway.
4Wait two minutes to allow the Thomson Gateway to complete the start up phase.
Connect your computer to the Thomson Gateway
Setting up a wireless connections
For more information on how to setup a wireless connection to your Thomson Gateway, see “3 Wireless Access” on page 23.
Setting up a wired connection
For more information on how to setup a wired connection (i.e. an Ethernet connection) to your Thomson Gateway, see “1.4 Connecting a Computer Using the Ethernet Cable” on page 12.
9 | |
|