Seiko Group TM-L60 manual GS C 0 m n, PER Feed switch or turning the power on

• "m" indicates the number of digits to be printed.

m = O: Prints the actual digits indicated by numerical value. In this case “n” has no meaning.

4 6

	•	“mu indicates adjusting direction.
		When	m = < * * * * * 0>B, positioning is adjusted in the
		normal	direction.
		When	m = <* * * * * * 0>B, positioning is adjusted in the
		reverse	direction.
	•	"n” means the adjustment amount. It is n/360 inches.
[Notes]	•	The setting beyond the tip of a label is not available. If the
		adjustment amount that goes beyond the label tip is specified,
		the starting position will be set to the label tip.
		Thus, any adjustment amount that will cause the printing width
		on a label to be narrower than 255/360 inches (see the figure
		below) cannot be set. Specifying such an amount will cause the
		starting position to be set at 255/360 inches.
	•	The default setting for the starting position is about 1.5 mm be
		low the label tip.
	• This command is effective only when ‘label print” is selected.
	•	Make sure to set the starting position by considering the align-
		ment of the starting position will be split out approx. ±1 mm be
		cause the paper is bent.
	•	This command is valid only after setting for the starting position
		by executing commands (FF, GS FF, GS <), pressing the PA-
		PER FEED switch or turning the power on.
	•	When position is adjusted in the reverse direction, the position of
		the first label may shift approx. ±1 mm. To prevent this, feed the
		first label through the machine without printing on it.

			•••••••••
[Default]	None
		I	I
[Reference]	FF, GS FF

b default position

b S t a r t i n g p o s i t i o n

(set by this command

GS C 0 m n

[Name]	Select counter print mode
[Format]	<1D>H<43>H<30>H<m><n>
[Range]	0 ≤ m ≤ 5
	0 ≤ n ≤ 2
[Description]	Selects print mode for the serial number counter.