Sharp XV-Z30000 appendix Computer Image Adjustment SIG-ADJ Menu, Setting the Resolution

Computer Image Adjustment (“SIG-ADJ” Menu)

	Pict.	SIG-ADJ		SCR		PRJ		Net.
	Clock			0
	Phase			0
	H-Pos			0
	V-Pos			0
	Reset
	Resolution
	Auto Sync				On
	Signal Type				Auto
*	Video Setup				0IRE
	Dynamic Range				Auto
		Signal Info : 1080P
	H : XX.X		kHz/			V : XX.X	Hz
	SEL./ADJ.					ENTER
	RETURN					END

* Displayed when the input mode is HDMI input.

Menu operation n Page 42

Setting the Resolution

Ordinarily, the type of input signal is detected and the correct resolution mode is automatically selected. However, for some signals, the optimal resolution mode in “Resolution” in the “SIG- ADJ” menu may need to be selected to match the computer display mode.

Note

•Avoid displaying computer patterns which repeat every other line (horizontal stripes). (Flickering may occur, making the image hard to see.)

•Information on the currently selected input signal can be confi rmed in item 7 on page 50.

Adjusting the Computer Image

Use the SIG-ADJ function in case of irregularities such as vertical stripes or flickering in portions of the screen.

Selectable	Description
items
Clock	Adjusts vertical noise.
Phase	Adjusts horizontal noise (similar to
	tracking on your VCR).
H-Pos	Centers the on-screen image by
	moving it to the left or right.
V-Pos	Centers the on-screen image by
	moving it up or down.

Note

•You can automatically adjust the computer image by setting “Auto Sync” in the “SIG-ADJ” menu to “On”, or pressing AUTO SYNC on the remote control.

•Depending on the type of input signal, the adjustment range for each setting may vary or the adjustment may not be available at all.

•To reset all adjustment items, select “Reset” and press ENTER.

Auto Sync (Auto Sync Adjustment)

Selectable	Description
items
On	Auto Sync adjustment will occur when
	the projector is turned on or when the
	input signals are switched, when con-
	nected to a computer.
Off	Auto Sync adjustment is not
	automatically performed.

Note

•Auto Sync adjustment is also performed by pressing AUTO SYNC on the remote control.

•When setting “Auto Sync” to “Off”, and if AUTO SYNC is pressed, Auto Sync will be executed in “On” mode. If the button is pressed again within one minute, Auto Sync will be executed in “On” mode.

•The Auto Sync adjustment may take some time to complete, depending on the image of the computer connected to the projector.

•When the optimum image cannot be achieved with Auto Sync adjustment, use manual adjustments.

Features Useful

49