Sharp XV-Z30000 appendix 68-70

Problem		Check	Page
3D images are not	ξ	Switch to 3D mode.	68-70
displayed.
	ξ	Is “3D Auto Change” set to “No”? Press 3D ON/OFF to switch to	70
		3D mode.
	ξ	If “3D Auto Change” is set to “Yes” but no 3D images are dis-	70, 71
		played, check the display format of the content being viewed.
		Some 3D image signals may not be recognized as 3D images auto-
		matically. Press 3D MENU to select the appropriate display format
		for the 3D image.
	ξ	The IR emitter is not correctly connected to the projector.	67
	ξ	Make sure that the IR emitter is located within the proper operating	67
		range.
	ξ	The 3D Glasses are not turned on.	66
	ξ	The 3D Glasses are set to 2D mode.	66
	ξ	The 3D Glasses operate by receiving the infrared signal from the IR	74
		emitter. Do not place anything between the IR emitter and the infra-
		red receiver on the 3D Glasses.
3D Images flicker when	ξ	Images may appear to flicker when fluorescent light or ambient	–
watching in a room.		light enters your vision.
		-Turn off the lights.
		-Block any ambient light.
Ghosting (a double im-	ξ	Use “Invert” to change the setting.	70
age) occurs without the
		A signal that does not support 3D is being received. Check whether	82
image appearing in 3D.	ξ
		a signal that supports 3D is being received.
	ξ	If the projector is connected to a computer for 3D image playback,	–
		check that a stereoscopically-enabled application is being used.
		- Use the applicable software
		- Configure your 3D application at the correct 3D format, resolu-
		tion and refresh rate. To support 3D, your 3D application must be
		configured to run at the correct settings for this projector.
	ξ	If there is strong ambient light, block the light. High intensity light-	–
		ing can interfere with communication between the 3D Glasses and
		the screen, resulting in some flicker.
	ξ	A picture simultaneously projected from more than two projectors	–
		may not appear 3D. Use only one projector at a time.
The projected image is dark.	ξ	When a 3D image is projected, the screen may appear darker than	–
		normal.
The 3D Glasses turn off	ξ	Is there an obstacle between the 3D Glasses and the IR emitter,	–
automatically.		or is something covering the infrared receiver on the 3D Glasses?
		The 3D Glasses turn off automatically after 3 minutes if no signal
		is received. Do not place anything between the IR emitter and the
		infrared receiver on the 3D Glasses.
Pressing the power but-	ξ	The battery in the 3D Glasses is exhausted. If the LED light does	65
ton on the 3D Glasses		not light after pressing the power button for more than one second,
does not cause the LED		the battery is exhausted. Replace the battery.
light to light.

This unit is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation or interference. If this should happen, unplug the unit and plug it in again after more than 5 minutes.

Appendix

85