Sharp UX-A255 operation manual Important safety information

Page 5

As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units.

Important safety information

Do not disassemble this machine or attempt any procedures not described in this manual. Refer all servicing to qualified service personnel.

Do not install or use the machine near water, or when you are wet. For example, do not use the machine near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. Take care not to spill any liquids on the machine.

Unplug the machine from the power outlet and telephone jack and consult a qualified service representative if any of the following situations occur:

-Liquid has been spilled into the machine or the machine has been exposed to rain or water.

-The machine produces odors, smoke, or unusual noises.

-The power cord is frayed or damaged.

-The machine has been dropped or the housing damaged.

Do not allow anything to rest on the power cord, and do not install the machine where people may walk on the power cord.

This machine must only be connected to a 120 V, 60 Hz, grounded (3-prong) outlet. Connecting it to any other kind of outlet will damage the machine and invalidate the warranty.

Never insert objects of any kind into slots or openings on the machine. This could create a risk of fire or electric shock. If an object falls into the machine that you cannot remove, unplug the machine and consult a qualified service representative.

Do not place this machine on an unstable cart, stand or table. The machine could be seriously damaged if it falls.

Never install telephone wiring during a lightning storm.

Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

Never touch bare telephone wires or terminals unless the telephone line has been disconnected at the network interface.

Use caution when installing or modifying telephone lines.

Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.

Do not use a telephone to report a gas leak in the vicinity of the leak.

The power outlet must be installed near the equipment and must be easily accessible.

3

Page 4 Page 6
Image 5
Page 4 Page 6
Contents UX-A255 For Your Records Introduction Recommended paper weight is 20-lb. Copy Public switched telephone networkITU-T Ccitt G3 mode Yes cannot be used if power failsImportant safety information Table of Contents Making Copies Special Functions Look at the Operation Panel START/MEMORY key Resolution / Reception Mode keyFunction key OpenLCR keyUnpacking Checklist InstallationPoints to keep in mind when setting up About condensationConnecting the power cord Connecting the handsetConnections ConnectionsConnecting the telephone line cord Comments Attach the paper tray and paper tray extensionLoading the Imaging Film Loading the Imaging FilmInsert the green gears Remove the new roll of imaging film from its packagingInsert the film into the print CompartmentLoading Printing Paper Loading Printing PaperPrint contrast setting Setting the paper sizePress Function once Times Entering Your Name and Fax NumberEntering Your Name and Fax Number Enter your fax number by pressing the number keys max digits Setting the Date and Time Setting the Date and TimeFebruary, 12 for December, etc Example January Enter a two-digit number for the day 01 to Example the 5 thDaylight Saving Time Setting the Reception Mode Setting the Reception ModeSetting the reception mode Volume Adjustment Volume AdjustmentPress or until the display shows the desired volume level SpeakerIf you selected Ringer OFF OK ? HandsetRinger Setting Up and Using OpenLCR Press OpenLCR, 5 , and then START/MEMORY Registering by faxRegistering by phone Follow the instructions you hear Registering through OpenLCR’s Web siteDownloading receiving the rate data manually Using OpenLCRMark Meaning Press Function once and once To stop using OpenLCRTemporarily turning off OpenLCR What to do if you cannot connect to OpenLCR Changing your user profileWhat to do if E appears in the display To download new rate data Press Function once OncePress 1 SET to set the new phone number Press OpenLCR , Function Changing the Short Time and Long Time settingsSelecting a long or short call Enter a 2-digit number 01 to Press Memo once Once Using the Answering MachineExample Operating the Answering Machine When finished, replace the handset or pressTo listen to the outgoing message Activating the answering machineToll Saver OFF Number of rings in TAD mode Toll Saver functionMessages will play Listening to received messagesPress Play Recording phone conversations Erasing received messagesRecording reminders and messages for other users Setting ICM time Optional Answering Machine SettingsOptional Answering Machine Settings Fax reception on TAD failurePress To turn on automatic fax OGM only modeReception, or To turn it off Press Function onceTransfer Function Press To turn on OGM only mode To turn it offProgramming the transfer number Transfer FunctionPress the number keys to enter the transfer number Recording the transfer messagePress Memo once Twice Delete the messageTurning the Transfer function on and off Checking or erasing the transfer messageOverride Ringing Programming the override codePress once and 3 times Overriding the answering machineRemote code number Remote OperationsToll Saver Remote OperationsEnter your remote code number and then press Retrieving your messagesUnless you press twice Other remote operations Changing the fax reception modeTAD mode FAX mode TEL mode Turning the Transfer function on or off Recording a new outgoing messageChanging the transfer telephone number To turn Transfer on PressTo turn off OGM only mode Press 1 , 2 , To turn on OGM only mode Press 1 , 1 ,Recording a new transfer message Recording a MemoTransmittable Documents Size and weightSending Faxes Loading the Document Loading the DocumentOther restrictions Adjusting the Resolution and Contrast Adjusting the Resolution and ContrastResolution settings Load the documents Contrast settingsSending a Fax by Normal Dialing Sending a Fax by Normal DialingPick up the handset or press Speaker Listen for the dial tone Dial the number of the receivingStoring fax and phone numbers for automatic dialing Sending a Fax by Automatic DialingSending a Fax by Automatic Dialing Enter the fax or voice number by pressing the number keysTo return to Return to to store another number, or pressMake the desired changes to the name Editing and clearing auto-dial numbersSelect Edit or Clear Return to to edit or clear another number, or press Using an auto-dial numberReturn to the date and time display If you are sending a fax, load the documentsSending a fax by Direct Keypad Dialing Automatic redialing RedialPress 1 to select YES, or Error Correction ModeSelect no Press to return to the date and time displayBroadcasting sending a fax to multiple destinations Sending a Fax From MemorySending a Fax From Memory If desired, pressIf the memory becomes full Memory transmissionChanging the number of rings Using FAX ModeReceiving Faxes Using TEL Mode Using TEL ModeReplace the handset Display shows Receiving and thenOptional Reception Settings Optional Reception SettingsFax Signal Receive Press To turn on the function, or Reception RatioPress To select AUTO, or 2 to Select 100%Substitute Reception to Memory Substitute Reception to MemoryLoad the documents face down. Maximum of 10 pages Making CopiesCopy Cut-off Special Functions Caller ID Requires Subscription to ServicePress YES to turn on Caller ID To turn off Caller ID, press 2 and go To StepHow Caller ID operates Caller ID Requires Subscription to ServiceDisplay messages Press START/MEMORY to store your area codeViewing the Caller ID list When you have finished viewing the listPress Twice Dialing and transmission begin FaxPriority Call To delete calls from the Caller ID listBlocking voice calls Distinctive Ring Requires Subscription to Service Distinctive Ring Requires Subscription to ServiceBlocking Reception of Unwanted Faxes Blocking Reception of Unwanted FaxesPress START/MEMORY to print the list Printing ListsPress or until the desired list appears in the display Once Telephone Number List Setup ListMessage List Caller-ID ListHeadings in Transaction Report Transaction ReportTransaction Report print condition Print head MaintenancePlace the imaging film back in the print compartment Scanning glass and rollersIf the scanning glass is difficult to clean HousingProblems and Solutions TroubleshootingLine error Problem SolutionProblems and Solutions Dialing and transmission problemsReception and copying problems See Loading the Imaging Film in Chapter General problemsMessages and Signals Messages and SignalsReception to Memory on Recalling Audible signalsClearing Paper Jams Clearing Paper JamsClearing a jammed document Clearing jammed printing paper Ordering Parts Setup GuideHandset cord Telephone line cordFCC Regulatory Information FCC Regulatory InformationA R P Material Safety Data Sheet 2/2 Sending Faxes Quick Reference GuideTransmisión de mensajes telefax Guía de referencia rápida102 IndexIndex Page Page Page Remote Operation Card Remote Commands Limited Warranty Sharp Corporation
Top Page Image Contents