Sharp MX-M452N, MX-M502N, MX-M282N, MX-M362N manual Trays 1 to, Bypass tray and tray

PLACING ORIGINALS

Print side face up or face down

Paper is loaded with the print side face up or face down depending on the paper type and tray.

Trays 1 to 4

Load the paper with the print side face up.

However, if the paper type is "Letter Head" or "Pre-Printed", load the paper with the print side face down*.

Bypass tray and tray 5

Load the paper with the print side face down.

However, if the paper type is "Letter Head" or "Pre-Printed", load the paper with the print side face up*.

*If "Disabling of Duplex" is enabled in the system settings (administrator), load the paper in the normal way (face up in trays 1 to 4; face down in the bypass tray and tray 5).

Paper that cannot be used

• Special media for inkjet printers	• Irregularly shaped paper
(fine paper, glossy paper, glossy film, etc.)	• Stapled paper
• Carbon paper or thermal paper	• Damp paper
• Pasted paper	• Curled paper
• Paper with clips	• Paper on which either the print side or the reverse side
• Paper with fold marks	has been printed on by another printer or multifunction
• Torn paper	device.
• Oil-feed transparency film	• Paper with a wave-like pattern due to moisture
• Thin paper less than 56 g/m2 (15 lbs.)	absorption
• Paper that is 210 g/m2 (80 lbs.) or heavier

Non-recommended paper

•Iron-on transfer paper

•Japanese paper

•Perforated paper

• Various types of plain paper and special media are sold. Some types cannot be used with the machine. Contact your dealer or nearest authorised service representative for advice on using these types of paper.

•The image quality and toner fusibility of paper may change due to ambient conditions, operating conditions, and paper characteristics, resulting in image quality inferior to that of SHARP standard paper. Contact your dealer or nearest authorised service representative for advice on using these types of paper.

•The use of non-recommended or prohibited paper may result in skewed feeding, misfeeds, poor toner fusing (the toner does not adhere to the paper well and can be rubbed off), or machine failure.

•The use of non-recommended paper may result in misfeeds or poor image quality. Before using non-recommended paper, check if printing can be performed properly.

21