AMX NXI-x000 Series manual Guide for details

Introduction

NI-4000 Specifications (Cont.)

Rear Panel Connectors (Cont.):

Program port	• RS-232 DB9 connector (male) can be connected to a DB9 port on a
	computer; used with serial commands, NetLinx programming commands,
	other DB9 capable devices, and to upload/download information from the
	NetLinx Studio 2.4 program.
Configuration DIP switch	• Sets the communication parameters for the Program port.
ID pushbutton	• Provides the NetLinx ID (Device only) assignment for the device.
	• The D notation is used to represent a device number.
	• Refer to the NetLinx Integrated Controller WebConsole & Programming
	Guide for details.
Ethernet port	• RJ-45 port for 10/100 Mbps communication. This port automatically
	negotiates the connection speed (10 Mbps or 100 Mbps) and whether to
	use half duplex or full duplex mode.
Ethernet Link/Activity LED	• LEDs show communication activity, connection status, speeds, and mode
	information:
	SPD (speed) - Yellow LED lights On when the connection speed is 100
	Mbps and turns Off when the speed is 10 Mbps.
	L/A (link/activity) - Green LED lights On when the Ethernet cables are
	connected/terminated correctly, and blinks when receiving Ethernet data
	packets.
AXlink LED	• Green LED indicates the state of the AXlink connector port.
	• Normal AXlink activity = 1 blink/second
	• Abnormal AXlink activity = cycle of 3 consecutive blinks and then Off
AXlink port	• 4-pin 3.5 mm mini-Phoenix (male) connector provides data and power to
	external control devices.
Power port	• 2-pin 3.5 mm mini-Phoenix (male) connector
CardFrame Number	• Sets the starting address for the Control Cards in the CardFrame.(Factory
DIP switch	default CardFrame DIP switch value = 0).
	• The Control Card address range is 1-3064.
NetLinx Control Card	• Four 20-pin (male) connectors that bridge the gap between the Control
connectors (1-4)	Cards in the CardFrame and external equipment.
Included Accessories:	• 2-pin 3.5 mm mini-Phoenix (female) PWR connector (41-5025)
	• 4-pin 3.5 mm mini-Phoenix (female) AXlink connector (41-5047)
	• 10-pin 3.5 mm mini-Phoenix (female) I/O connector (41-5107)
	• Installation Kit (KA2105-01):
	8-pin Relay Common Strip
	Four rack mount screws
	Four washers
	• NI-4000 Quick Start Guide
	• Two 8-pin 3.5 mm mini-Phoenix (female) Relay connectors (41-5083)
	• Two CC-NIRC IR Emitters
	• Two removable rack ears (62-2105-07)

NI-2000, NI-3000, NI-4000 Hardware Reference Guide 13