MULTI-TASKER™
Command Format: [RMCn1Cn2…GkUi]
Cn | = Card ID (n= # from 1 to max slots) |
Gk | = Group number (k = # from |
Ui | = Unit ID (i = # from |
Example:
Group 1 consists of the cards located in slots numbered 1, 2, 3, 4 and 5. Remove just cards #4 and #5 from the group by sending the command [RMC4C5G1]. The system will return the following feedback:
G1=C1C2C3
26.[RMG]
This command may be used to delete an entire group, or all groups.
REMOVE ONE GROUP MEMBERS
Remove all the members from the group, effectively deleting the group.
Command Format: [RMGkUi]
Gk = Group number (k = # from
Ui = Unit ID (i = # from
Example:
Group 1 consists of the cards located in slots number 1, 2 and 3. Remove all cards from the group by sending the command [RMG1]. The system will return the following feedback:
G1=EMPTY
REMOVE ALL GROUPS
Remove all the members from every group, effectively deleting all groups.
Command Format: [RMGÜUi]
Ui = Unit ID (i = # from
Example:
Group 1 consists of cards 1 and 2. Group 2 consists of cards 1, 2, 3, 4 and 5. Delete all the groups by sending the command [RMGÜ]. The system will return the following feedback:
16 |
27.[RD]
This command reads and then displays the members in each group.
Command Format: [RDGkUi]
Gk = Group number (k = # from
Ui = Unit ID (i = # from
Example:
The cards in slots 1, 2 and 19 are part of group 5. Read the member data for group 5, by sending the command [RDG5]. The system will return feedback as follows:
G1=C1C2C19
The feedback shows G1 (Group 1) and then the cards that make up Group 1. In this case, Group 1 includes C1, C2 and C19.
28.[CLM]
This command removes the members in a group and leaves the group empty. It is equivalent to sending the [RMGkUi] command without card references.
Command Format: [CLMGkUi]
Gk = Group number (k = # from
Ui = Unit ID (i = # from
Example:
Group 5 of Unit ID 1 contains the cards in slots 1, 2 and 19. Read the member data for group 5 of Unit ID 1. Send the command [RDG5U1] and receive the following feedback:
G1=C1C2C19
Now, clear group 5 by sending the command [CLMG5U1]. Reread the member data as above and note the following feedback:
G1=EMPTY
16