MULTI-TASKER™
7.3SUMMARY OF COMMANDS Card Commands
1) [VER] | Receives software version |
2)[C] Receives status of the card
3) [CnS] | Save card settings |
4)[?] Show system cards
5) | [?C] | Show card information |
6) | [STA] | Enable/disable auto feedback |
7) | [ON] | Turn output ON for card/group |
8) | [OFF] | Turn output OFF for card/group |
9) | […S] | Save card settings |
10) | […F] | Display command feedback |
11) | […P] | Sets the path, preload for [SW] |
12) | [SW] | Switch preloaded output buffer |
13) | [SIG] | Signal Detect |
14) | [AUTO] | |
15) | [CLR] | Reset card to default values |
16) | [TEST] | Test internal memory IC's |
17) | [FBD] | Feedback delay on/off |
18) | [RSI] | Reset Card ID’s |
19) | [SIDn] | Set all Card ID’s |
20) | [SIDnCi] Set one Card ID | |
21) | [SID+n] | Set Card ID offset |
22) | [RSN] | Read Card slot number |
23) | [HELP] | Display available commands |
Group Commands | ||
24) | [WR] | Groups multiple cards |
25)[RMC] Remove members from group
26)[RMG] Delete group
27) | [RD] | Displays group members |
28) | [CLM] | Delete group |
17 |
7.4 MENU MODE
MENU MODE commands are
MENU commands may be issued in response to prompts from within MTSetup™ or other
The MENU driven commands are only available with
NOTE: In MTSetup™, send the command [VER] from the Terminal Window. The system will respond with feedback similar to the following:
Check the last three digits against those above to determine if the MENU MODE option is available.
7.4.1 MENU COMMAND DEFINITIONS
Refer to section 7.2 for details on functions and examples. Following is a
MENU | COMMAND |
Control |
|
Select | n/a |
Save | [CnS], [..S] |
Clear | [CLR], [CLRG] |
Switch | [ON], [OFF] |
Setup |
|
Group | [WR], [CLM], [RMC], [RMG] |
Status | [VER], [C] |
Help | [HELP] |
| [?], [?Cn], [...F], [...P], |
| [AUTO], [FBD], [RDG], [RSI], |
Not Available | [RSN], [SID], [SIDnCi], |
| [SID+n], [SIG], [STA], [SW], |
| [TEST] |
17