INSTALLING YOUR | 6 |
Step 1. Slide the
Step 2. The LED on the card panel will turn red indicating that the card is in full operation. An LED that is blinking red indicates that the card is experiencing a problem. If the LED is blinking, see Troubleshooting Guide in section 8. On the
Step 3. Connect a coaxial cable from the video source to the input connector of the
Step 4. Starting from the left, identify the slot number where the
8 |
OPERATION | 7 |
7.1 RS-232 CONTROL
When used in the
7.1.1 RS-232 INTERFACE
The
1.Square brackets “[ ]” are part of the command.
2.Use uppercase letters for all commands.
After processing a command, an OK or ER will be returned as feedback if "F" is included at the end of a command string.
Commands ending in "S" will be saved into memory. Commands not ending in "S" will still be executed but will not be restored when the system is reset or powered OFF then ON.
7.2 DESCRIPTION OF COMMANDS
Each command consists of three parts: Function, Card ID, and Unit ID.
[ Function , Card ID , Unit ID ]
Example: [VERC3U2]
VER | = Function |
C3 | = Card ID or Group ID |
U2 | = Unit ID |
For Function, see a detailed explanation under each command description.
8