Altinex Policy, No Display | Altinex MT104-100/103 specification

MULTI-TASKER™

Cause 2 The card and its serial device are not communicating.

Solution 1: Turn the system OFF and then ON again. If there is still an error, see Solution 3.

Solution 2: Call ALTINEX at (714) 990-2300.

Cause 3: RS485 communication error

Solution 1: Make sure that the card is pushed all the way into the slot. If there is still an error, see Solution 2.

Solution 2: Turn the system OFF and then ON again. If there is still an error, see Solution 3.

Solution 3: If there is still a problem, call ALTINEX at (714) 990-2300.

8.3 NO DISPLAY

Cause 1: The source has a problem.

Solution: Check the source and make sure that there is a signal present and all source connections are correct. If the source is working and there is still no display, see Cause 2.

Cause 2 The card input is not selected.

Solution: Select the card input. See RS-232 accessible commands in section 7. If there is still no display present, see Cause 3.

Cause 3 Cable connections are incorrect.

Solution: Make sure that the cables are connected properly. Also, make sure that the continuity and wiring are good. If there is still no display present, see Cause 4.

Cause 4: The display has a problem.

Solution: Make sure that the display is powered. If there is still no display, call ALTINEX at (714) 990-2300.

400-0082-005

ALTINEX POLICY

9.1 LIMITED WARRANTY/RETURN POLICY

Please see the Altinex website at www.altinex.com for details on warranty and return policy.

9.2CONTACT INFORMATION ALTINEX, INC

592 Apollo street

Brea, CA 92821 USA

TEL: 714 990-2300

TOLL FREE: 1-800-ALTINEX

WEB: www.altinex.com

E-MAIL:solutions@altinex.com