Allied Telesis AT-9000/12POE, AT-9000/28POE manual Power LED Is Off

Page 72

AT-9000 Gigabit Ethernet Switch Installation Guide

Power LED Is Off

Check the PWR LED on the front of the switch. If the LED is off, indicating that the unit is not receiving power, do the following:

Make sure the power cord is securely connected to the power source and to the AC connector on the back panel of the switch.

Verify that the power outlet has power by connecting another device to it.

Try connecting the unit to another power source.

Try using a different power cord.

Check that the voltage from the power source is within the required levels for your region.

72

Image 72
Contents Installation Guide Page Electrical Safety and Emissions Standards Translated Safety Statements Contents Snmp Figures Figures Tables Tables Preface Document Conventions Contacting Allied Telesis AT-9000 Gigabit Ethernet Switch Installation Guide Overview ChapterSwitch Models and Features AT-9000 Series ModelsPower over Ethernet RS-232 Console PortManagement Methods AT-9000 Series Gigabit Ethernet Switches AT-9000/12POE SwitchAT-9000/12POE Switch Front and Rear Panels AT-9000/28 Switch SFP/RJ45AT-9000/28POE Switch AT-9000/28POE Switch Front and Rear PanelsAT-9000/28SP Switch AT-9000/28SP Switch Front and Rear PanelsAT-9000/52 Switch AT-9000/52 Switch Front and Rear Panels10/100/1000Base-T Twisted-Pair Ports Wiring Configuration Maximum Distance 10Mbps 100Mbps 1000Mbps Cable Type Non PoE PoE+ Power Over Ethernet Powered Device Classes Port Prioritization Wiring Implementation SFP Slots 10/100/1000 SFP Slot Base-T PortOverview Combo Ports Overview Console Port Mode LED Select Button LEDsLink LED Mode SFP LINK/ACT LEDs EcoFriendly Button Front Panel ecoFriendly ButtonPower Supplies Power Connectors AT-9000 Gigabit Ethernet Switch Installation Guide Beginning the Installation Installation Procedures Reviewing Safety Precautions AT-9000 Gigabit Ethernet Switch Installation Guide Beginning the Installation AT-9000 Gigabit Ethernet Switch Installation Guide Selecting a Site Unpacking the Switch Installing the Switch on a Table or Rack Installing the Switch on a Table or Desktop Installing the Switch in a Rack Attaching Brackets for Rack Mounting Mounting the Switch in a Rack AT-9000 Gigabit Ethernet Switch Installation Guide Cabling the Networking Ports AT-9000 Gigabit Ethernet Switch Installation Guide Powering On the Switch Applying AC Power Connecting the AC Power CordPowering On the Switch Starting a Local Management Session Powering On the Switch Management Methods Local Management Telnet ManagementSecure Shell Management Web Browser Management AT-9000 Gigabit Ethernet Switch Installation Guide Adding a Management IP Address Awplus enable Troubleshooting Power LED Is Off Twisted-Pair Port Link LED Is Off AT-9000 Gigabit Ethernet Switch Installation Guide Cannot Establish a Local Out-of-Band Management Session All Port LEDs Are Off Power Over Ethernet Fiber Optic Transceivers Slow Performance Between Switch and Host Device AT-9000 Gigabit Ethernet Switch Installation Guide Technical Specifications Physical SpecificationsAppendix a Environmental Specifications Power SpecificationsSafety and Electromagnetic Emissions Certifications Quality and ReliabilityCompliance Standards 10/100/1000Base-T Twisted-Pair Port Connectors Pin SignalPin Pair Signal Console Port PinoutsAT-9000 Gigabit Ethernet Switch Installation Guide