Allied Telesis AT-8500 Series manual Installing an Optional SFP Transceiver

Chapter 2: Installation

Installing an Optional SFP Transceiver

To install an optional SFP transceiver in an AT-8550SP switch, perform the following procedure:

Note

An SFP transceiver can be hot-swapped; you do not have to power off a switch to install it.

1.Unpack the SFP transceiver from its shipping container and store the packaging material in a safe location.

Note

You must use the original shipping material if you need to return the module to Allied Telesis.

Warning

An SFP transceiver can be damaged by static electricity. Be sure to observe all standard electrostatic discharge (ESD) precautions, such as wearing an antistatic wrist strap, to avoid damaging the module.

2.Check that the SFP transceiver includes the items listed below. If any item is missing or damaged, contact your Allied Telesis sales representative for assistance.

ˆOne SFP module

ˆInstallation Guide

ˆWarranty card

Note

For fiber optic cabling specifications, refer to the SFP installation guide provided with the module.

3.Follow these guidelines to ensure proper performance of your SFP transceiver:

ˆSFP transceivers are static sensitive. To prevent Electrostatic Discharge (ESD) damage, follow your normal board and component handling procedures.

ˆSFP transceivers are dust sensitive. Do not remove the dust cover from the port until you are ready to attach the fiber optic cable.

ˆThe most common source of contaminants in the optical bore is

62