Allied Telesis AT-8500 Series manual Installation

Chapter 2: Installation

ˆParity: None

ˆStop bits: 1

ˆFlow control: None

Note

The port settings are for a DEC VT100 or ANSI terminal, or an equivalent terminal emulator program.

Note

When you reset or power cycle the switch during a local management session, you will see the following prompt: Press <CTRL>B to go to Boot Prompt. This message is intended for manufacturing purposes only. If you inadvertently display the boot prompt (=>), type boot and press Return to start the switch.

4.Press Return.

You are prompted for a user name and password.

5.To view and configure all of the switch’s operating parameters, enter the login name “manager”. The default password for manager access is “friend”. To only view the parameter settings, enter the login name “operator”. The default password for operator access is “operator”. The user names and passwords are case-sensitive.

The Main Menu is displayed.

If you logged in with manager access, you can now fully manage the switch using the management interface. For instructions, refer to the AT-S62 Management Software User’s Guides. The guides are available from the Allied Telesis web site at www.alliedtelesis.com and on the CD included with the switch.

74