Allied Telesis AT-8500 Series manual Installation

Page 50

Chapter 2: Installation

Warning: This unit might have more than one power source. To reduce the risk of electric shock, disconnect all power sources before servicing the unit.  E30

If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack environment may be greater than the room ambient temperature. Therefore, consideration should be given to installing the equipment in an environment compatible with the manufacturer’s maximum rated ambient temperature (Tmra).  E35

Caution: Installation of the equipment in a rack should be such that the amount of air flow required for safe operation of the equipment is not compromised.  E36

Warning: Reliable earthing of rack-mounted equipment should be maintained. Particular attention should be given to supply connections other than direct connections to the branch circuits (e.g., use of power strips).  E37

Warning: To reduce the risk of electric shock, the PoE ports on this product must not connect to cabling that is routed outside the building where this device is located.  E40

50

Image 50
Contents Installation Guide Page Electrical Safety and Emissions Standards Translated Safety Statements Contents Page Figures Figures Tables Tables Preface Safety Symbols Used in this Document Symbol Meaning DescriptionWhere to Find Web-based Guides Management Software Updates Contacting Allied TelesisOverview ChapterModel Configurations Model ConfigurationModel Descriptions Port LEDs System LEDsShows the front and back panels of the AT-8524M switch Shows the front and back panels of the AT-8524POE switch Shows the front and back panels of the AT-8550GB switch AT-8550SP Switch Front and Back Panels Port Descriptions 10/100Base-TX Twisted Pair PortsMaximum Distance 10/100/ 1000Base-T Twisted Pair Ports 100Base-FX Fiber Optic Ports Type of Cable Power Over Ethernet Minimum Power Maximum Power Class Gbic and SFP Slots Gbic ModuleModule Expansion Slots State Description Twisted Pair Port LEDs LED Mode Select ButtonLEDs Mode FDX OFF Indicates that the port is operating at 10 or Fiber Optic Port LEDs Gbic and SFP Expansion Slot LEDs Maste RS-232 Terminal Port Power Options and Connectors AC Power Connector DC Power Connector Few Basics about Ethernet Switching MAC Address Table Duplex ModeStore Forward Back Pressure and Flow ControlOverview Collapsed Backbone Topology Power Workgroup TopologyNetwork Topologies Mixed Topology Mixed Topology Overview Installation Reviewing Safety Precautions Page Installation Selecting a Site for the Switch Model Speed Cable Type Planning the InstallationMaximum Maximum Unpacking the Switch Installing the Switch in a Rack Installation Page Installing an Optional Expansion or Stacking Module Removing the Expansion Slot FaceplateAT-A46 Installing an Optional Gbic Ferrules of the optical connector Bore Installing an Optional SFP Transceiver Page Cabling the Switch Cabling Twisted Pair PortsCabling Fiber Optic Ports SC Port Transmitter Fiber Connector Cabling Expansion Modules Powering on an AC Powered Switch Page Wiring and Powering on an DC Powered Unit Positive, Ground, and Negative Terminals8mm ±1mm 31in. ±0.039in Installation Starting a Local Management Session Installation Warranty Registration Installation PWR LED is Off Twisted Pair Port Link LED is OffFiber Optic Port Link LED is Off PoE Device is Not Receiving Power Fault LED is On ContinuouslyCannot Establish a Local Management Session Appendix a Physical SpecificationsEnvironmental Specifications Power Specifications Safety and Electromagnetic Emissions CertificationsPin MDI Signal MDI-X Signal Pin MDI SignalSignal RJ-45 Twisted Pair Port PinoutsMDI Configuration MDI-X Configuration Pinout Pair Unused RX- and Vport-2 TX- and Vport-2AT-8516F/SC Fiber Optic Port Specifications Pin Signal RS-232 Terminal Port PinoutsRPS Connector Port Pinouts Pin Definition3V RS Pin13 3.3V RS+ Dual SC Type Connector