APC iSCSI SATA II installation and configuration manual Enclosure, LCD Control Module LCM

2.9 Enclosure

2.9.1 LCD Control Module (LCM)

There are four buttons to control the subsystem LCM (LCD Control Module). These are:

c(Up) d(Down) (Enter) (Escape)

After booting up the system, the following screen shows management port IP and model name:

192.168.10.50 iSCSI-Model-Name ←

Press “”, the LCM functions “System Info,”, “Alarm Mute”, “Reset/Shutdown”, “Quick Install”, Volume Wizard”, “View IP Setting”, “Change IP Config” and “Reset to Default” will rotate by pressing c (up) and d (down).

When there is WARNING or ERROR level of event (LCM default filter), the LCM shows the event log to give users more detail from front panel too.

The following table is function description.

System Info	View System information of Firmware Version & RAM Size.
Alarm Mute	Mute alarm when error occurs.
Reset/Shutdown	Reset or shutdown controller.
Quick Install	Quick three steps to create a volume. Please refer to
	section 3.3 for operation in web UI.
Volume Wizard	Smart steps to create a volume. Please refer to next
	chapter for operation in web UI.
View IP Setting	Display current IP address, subnet mask, and gateway.
Change IP	Set IP address, subnet mask, and gateway. There are 2
Config	selections, DHCP (Get IP address from DHCP server) or set
	static IP.
Reset to Default	Reset to default sets password to default: 00000000, and
	set IP address to default as DHCP setting.
	Default IP address: 192.168.10.50 (DHCP)
	Default subnet mask: 255.255.255.0
	Default gateway: 192.168.10.254

[24]