14 en Programming | LE10 Radio Receiver |
|
|
5.3Delete a transmitter
NOTICE!
Per sequence only one transmitter can be deleted.
To start deleting:
–Press button T1 for min. 5 seconds and max. 10 seconds.
Device behavior
–The green LED stays permanently on, then after 5 seconds blinks fast 5 times.
–The red LED stays off and then blinks for 30 seconds.
Within these 30 seconds, activate the transmitter that you want to delete, the following behavior should be observed:
–The green LED stays permanently on.
–The red LED stays permanently on for 5 seconds and then turns off.
This indication confirms that the transmitter is deleted. You can repeat the sequence with another transmitter.
5.4Delete all transmitters
To start deleting
–Press button T1 for minimum 20 seconds and maximum 40 seconds.
Device behavior
–The green LED stays permanently on, then after 5 seconds, blinks fast 5 times. After 20 seconds, the green LED will blink for 20 seconds.
–At that moment, the red LED lights up permanently for 5
seconds then turns off.
This indication confirms that all transmitters are then deleted.
NOTICE!
If button T1 is pressed longer than 40 seconds, then the LE10 Radio Receiver will jump out of the programming mode.
F.01U.278.517 V2.0 2012.11 | User Manual | Bosch Security Systems |