Bosch Appliances LE10 Safety instructions, General safety instructions, Environmental conditions

Page 5

LE10 Radio Receiver

Safety instructions en

5

 

 

 

1Safety instructions

1.1General safety instructions

Installation and initial operation should only be carried out by trained service personnel.

1.2Environmental conditions

The LE10 Radio Receiver must not be located near a water tap or any other source of water. The electrical safety of the LE10 Radio Receiver is only guaranteed if the electrical installation is in accordance with the national regulations and if this installation works properly. The LE10 Radio Receiver may not be used in buildings prone to fire and explosion hazards.

The LE10 Radio Receiver may not be used under exposure to direct sunlight, to heat, to dust or to an excessive humidity (only use the equipment in a clean environment).

1.3Electrostatic Discharge (ESD)

WARNING!

The LE10 Radio Receiver contains highly sensitive electronic components. It should be opened only in an ESD protected environment with respect to the following precautions. Discharge yourself from electrostatic loads by touching a grounded conductive surface before opening the unit. Avoid touching conductive parts inside the LE10 Radio Receiver if not absolutely necessary.

Bosch Security Systems

User Manual

F.01U.278.517 V2.0 2012.11

Image 5
Contents LE10 Radio Receiver Page Table of Contents Technical data General safety instructions Safety instructionsEnvironmental conditions Electrostatic Discharge ESDCompatible transmitters Product informationGeneral description Main applications Mode Name DescriptionDescription of the different modes LE10 Radio Receiver as small stand alone call systemMode Name Description Connecting the power supply InstallationPower supply with the RJ12 power socket Power supply connected to a wired installationDimensions of the backside of the LE10 Radio Receiver Wall installationConnection compartment Connecting portsMode Description Switch number Mode selectionMode indication after power on Programming Enter programming modeProgram a transmitter in modes 1, 2 or To start programmingTo start deleting Delete a transmitterDelete all transmitters Programming in modes 6 or Program a door address in modes 3 orOperation Standby modeNormal mode modes 1 Activation of a MIYS37L Wristband Transmitter Dementia modeDetection of a MIYS37E Wristband Transmitter alone Activation of a programmed transmitter Dementia with Accompany modeRemote control mode Open receiver modes 6 Daily message with battery-low signalDaily messages in modes 1, 2 or Activation of a transmitter in the reception rangeStandby Extended MIYN46 mode 8, only with SWReset of a battery-low indication with button T1 Battery low indication until the battery is exchanged Dual channel receiver mode 9, only with SWBattery-low indication ABS Technical dataBosch Security Systems