Bosch Appliances LE10 user manual Extended MIYN46 mode 8, only with SW, Standby

Page 21

LE10 Radio Receiver	Operation en 21

6.7.2Reset of a battery-low indication with button T1

Device behavior

–The green LED stays permanently on.

–The red LED is already blinking every 10 seconds.

Upon pressing button T1 min. 1 second, there is a reset of the battery-low indication:

–The red LED turns off.

–Relay 2 switches off.

NOTICE!

If you disconnect and reconnect the power supply, the battery- low indication will be reset as well.

6.8Extended MIYN46 (mode 8, only with SW 1.10)

Programming and deleting of transmitters is done as in Mode 1.

Standby

–The green LED stays permanently on.

–The red LED is off.

–Relay 1 is switched off.

–Relay 2 is switched off.

When a MIYS37 transmitter, MIYS35 transmitter, MIYRAC contact, MIYMD ManDown Sensor are activated:

–The green LED stays permanently on.

–The red LED turns on for 2 seconds.

–Relay 1 is switched on for 2 seconds.

–Relay 2 is switched off.

When a MIYN46 transmitter’s red or blue button is pressed, or when one of its inputs is activated:

–The green LED stays permanently on.

–The red LED and Relay 1 switch on for 6 minutes or until the green button of the MIYN46 transmitter is pressed.

–Relay 2 is switched off.

Bosch Security Systems

User Manual

F.01U.278.517 V2.0 2012.11

Image 21

Contents LE10 Radio Receiver Page Table of Contents Technical data General safety instructions Safety instructionsEnvironmental conditions Electrostatic Discharge ESDProduct information General descriptionCompatible transmitters Main applications Mode Name DescriptionDescription of the different modes LE10 Radio Receiver as small stand alone call systemMode Name Description Connecting the power supply InstallationPower supply with the RJ12 power socket Power supply connected to a wired installationDimensions of the backside of the LE10 Radio Receiver Wall installationConnection compartment Connecting portsMode selection Mode indication after power onMode Description Switch number Programming Enter programming modeProgram a transmitter in modes 1, 2 or To start programmingDelete a transmitter Delete all transmittersTo start deleting Programming in modes 6 or Program a door address in modes 3 orStandby mode Normal mode modes 1Operation Activation of a MIYS37L Wristband Transmitter Dementia modeDetection of a MIYS37E Wristband Transmitter alone Dementia with Accompany mode Remote control modeActivation of a programmed transmitter Open receiver modes 6 Daily message with battery-low signalDaily messages in modes 1, 2 or Activation of a transmitter in the reception rangeExtended MIYN46 mode 8, only with SW Reset of a battery-low indication with button T1Standby Dual channel receiver mode 9, only with SW Battery-low indicationBattery low indication until the battery is exchanged ABS Technical dataBosch Security Systems