22 en Operation | LE10 Radio Receiver |
|
|
NOTICE!
A MIYN46 transmitter in repeated alarm mode extends the behavior of the LE10 by approximately 26 minutes. If several MIYN46 transmitters are programmed, each activated transmitter stops the sequence and starts its own sequence.
Battery-low indication:
–Relay 2 switches on for 2 seconds.
–The red LED flashes for 2 seconds, then blinks 1 second every 10 seconds.
For all MIYS35 and MIYS37 transmitters, the battery low status is triggered when the transmitter is activated or with the daily message. For all MIYN46 transmitters, the battery low status is triggered only with the daily message.
6.9Dual channel receiver (mode 9, only with SW 1.10)
Programming and deleting of transmitters is done as in Mode 1.
Standby
–The green LED stays permanently on.
–The red LED is off.
–Relay 1 is switched off.
–Relay 2 is switched off.
When a transmitter, that is matched on a odd position (1, 3, 5, etc.), is activated:
–Relay 1 switches on for 2 seconds.
–The red LED turns on for 2 seconds.
When a transmitter, that is matched on a even position (2, 4, 6, etc.), is activated:
–Relay 2 switches on for 2 seconds.
–The red LED blinks 1 second on, 1 second off, 1 second on.
Battery low indication (until the battery is exchanged)
–The red LED flashes during 2 seconds, then flashes 1 second every 10 seconds.
F.01U.278.517 V2.0 2012.11 | User Manual | Bosch Security Systems |