Bosch Appliances LE10 Programming, Enter programming mode, Program a transmitter in modes 1, 2 or

Page 13

LE10 Radio Receiver	Programming en 13

5Programming

5.1Enter programming mode

To enter programming mode, press simply button T1 for the desired time. See Section 4.1 Connecting ports, page 11.

NOTICE!

Both relays will not be activated in the programming mode.

5.2Program a transmitter in modes 1, 2 or 5

NOTICE!

Per programming sequence only one transmitter can be matched. You can program up to 20 transmitters.

To start programming

–Press button T1 for min. 1 second and max. 3 seconds.

Device behavior

–The green LED stays permanently on.

–The red LED blinks slowly for maximum 30 seconds. Within these 30 seconds, activate the transmitter that you want to match, the following behavior should be observed:

–The green LED and the red LED blink alternating for 6

seconds.

This indication confirms that the transmitter is programmed.

–If the transmitter is already programmed, then the red LED blinks fast for 6 seconds after activating the transmitter.

–If 20 transmitters are already programmed, then the red LED blinks fast for 10 seconds directly after activating the button T1 between 1 and 3 seconds.

You can repeat the sequence with another transmitter.

Bosch Security Systems

User Manual

F.01U.278.517 V2.0 2012.11

Image 13

Contents LE10 Radio Receiver Page Table of Contents Technical data General safety instructions Safety instructionsEnvironmental conditions Electrostatic Discharge ESDGeneral description Product informationCompatible transmitters Main applications Mode Name DescriptionDescription of the different modes LE10 Radio Receiver as small stand alone call systemMode Name Description Connecting the power supply InstallationPower supply with the RJ12 power socket Power supply connected to a wired installationDimensions of the backside of the LE10 Radio Receiver Wall installationConnection compartment Connecting portsMode indication after power on Mode selectionMode Description Switch number Programming Enter programming modeProgram a transmitter in modes 1, 2 or To start programmingDelete all transmitters Delete a transmitterTo start deleting Programming in modes 6 or Program a door address in modes 3 orNormal mode modes 1 Standby modeOperation Activation of a MIYS37L Wristband Transmitter Dementia modeDetection of a MIYS37E Wristband Transmitter alone Remote control mode Dementia with Accompany modeActivation of a programmed transmitter Open receiver modes 6 Daily message with battery-low signalDaily messages in modes 1, 2 or Activation of a transmitter in the reception rangeReset of a battery-low indication with button T1 Extended MIYN46 mode 8, only with SWStandby Battery-low indication Dual channel receiver mode 9, only with SWBattery low indication until the battery is exchanged ABS Technical dataBosch Security Systems