Chapter 4: AMI BIOS
SMBIOS Configuration
SMBIOS SMI Support
Select Enabled to enable the function of SMBIOS SMI Wrapper support for PnP Func
Remote Access Configuration
You can use this screen to select options for the Remote Access Confi guration. Use the up and down arrow keys to select an item. Use the <+> and
Remote Access
This feature allows the user to enable the function of Remote Access. The options are Enabled and Disabled.
If the item "Remote Access" is set to Enabled, you can select a Remote Access type and confi gure the following settings:
Serial Port Number
This feature allows the user to select the serial port for Console Redirection. The options are COM1 and COM2.
Base Address
This feature allows the user to set Base Address for the Serial Port Selected. The default setting is 2F8h, 8.
Serial Port Mode
This feature allows the user to set the serial port mode for Console Redirection. The options are 115200 8, N, 1, 57600 8, N, 1, 38400 8, N, 1, 19200 8, N, 1 and 9600 8, N, 1.
Flow Control
This feature allows the user to set the fl ow control for Console Redirection. The options are None, Hardware, and Software.
Redirection After BIOS POST
This feature allows the user to select Disabled to turn off Console Redirection after POST. Select Always to keep Console Redirection active all the time. (*Note: this setting may not be supported by some operating systems.) Select Boot Loader to keep Console Redirection active during POST and Boot Loader.