SUPER MICRO Computer AOC-SOZCR1, AOC-LPZCR1 manual

Page 33

Chapter 3: RAID Conﬁ guration

4.Use the up and down arrows to select the drive you wish to erase and press <Insert>. The following screen displays:

5.Make sure that the drive selected is the correct one; then, press <Enter>.

6.The following message displays: "Warning! Secure Erase will erase all informa- tion from the selected drive. Do you really want to continue?" Press <Y> to erase the drive. Press <N> to abort the procedure and return to the main menu.

3-17

Image 33

Contents Super AOC-LPZCR1/AOC-SOZCR1 Users Guide Table of Contents AOC-SOZCR1 Series the Terminator Socket Dimm ZCR Card IntroductionOperating Systems supported Key RAID FeaturesManagement support AOC-LPZCR1 Series -Low Proﬁle Skyhawk ZCR RAID CardHeadquarters EuropeAsia-Paciﬁc AOC-LPZCR1 Card Layout and Jumper Locations Chapter Technical Speciﬁcations and Software InstallationJumper and Connector Descriptions *AOC-LPZCR1 Jumper DescriptionDescription Activity LED Indicator Connectors and LED Indicators *AOC-LPZCR1Buzzer Connector I2C Cable ConnectionAOC-SOZCR1 Card Layout and Jumper Locations Front view AOC-SOZCR1Rear view AOC-SOZCR1 SMB Connector and Pin Deﬁnitions *AOC-SOZCR1 Connector and Header Descriptions *AOC-SOZCR1SMB I 2C 2C cable ConnectionSee Note 1 below Intelligent Interface Management SAF-TEGeneral Safety Guidelines ESD Safety GuidelinesAdding the Driver into an Existing System Creating the Driver Floppy DiskFor the Windows 32-bit Operating System For the Red Hat/SuSE Operating SystemInstalling the Driver into a New System For the Red Hat Operating SystemFor the SuSE Operating System AOC-LPZCR1/AOC-SOZCR1 Users Guide Chapter RAID Conﬁguration Conﬁguring Jumper SettingsUsing Adaptecs RAID Conﬁguration Utility SAS, Sata and Scsi settingsTo Use the Adaptec RAID Conﬁguration Utility RAID Conﬁguration Utility Main Menu Using the Array Conﬁguration UtilityArray Conﬁguration Utility Main Menu To Create ArraysPage To assign properties to the new array To Manage ArraysTo View the properties of Existing Arrays Deleting Arrays Setting a Bootable Array Adding a Hotspare Disk Drive Deleting a Hotspare Disk Drive To initialize Disk drives Initializing Disk DrivesPage Page Rebuilding Arrays To Rebuild an array To Rescan Disk drivesTo Secure Erase Drives Page Using the Controller Conﬁguration Utility Using Adaptecs SCSISelect UtilityUsing the Scsi Conﬁguration Utility Page Page Using Adaptecs SATASelect Utility Using the Sata Conﬁguration UtilityTo Use the SATASelect Utility To Use the SerialSelect Utility Using Adaptecs Serial Select UtilityUsing Physical Conﬁguration Utility To Use Disk Utilities *for Scsi only Using Disk UtilitiesPage To Format a Disk Drive To Use Disk Utilities *for Sata and SAS onlyTo Verify Disk Media To Exit the Adaptec RAID Conﬁguration UtilityChapter Troubleshooting Contacting Supermicros Technical Support