Chapter 2: Server Installation
2-5 Checking the Serverboard Setup
After you install the system in the rack, you will need to access the inside of the nodes to make sure the serverboard is properly installed.
Accessing the Inside of a Node (Figure 2-6)
1.Before removing a node, unplug all the cables that connect to that node.
2.To remove a node, first push the two latches (located near the handles) inward.
3.Grasp the handles and pull the node out from the rear of the chassis.
4.To remove the system from the rack completely, depress the locking tabs in the chassis rails (push the
Checking the Components and Setup
1.You may have one or two processors already installed in each of the two serverboards. Each processor needs its own heatsink. See Chapter 5 for instructions on processor and heatsink installation.
2.Your server system may have come with system memory already installed. Make sure all DIMMs are fully seated in their slots. For details on adding system memory, refer to Chapter 5.
3.You can install one
4.Make sure all power and data cables are properly connected and not blocking the chassis airflow. See Chapter 5 for details on cable connections.