Configuring Users
level
The access that a user is allowed:
zAdmin—The admin level user has total access to the IOLAN. You can create more than one admin user account but we recommend that you only have one. They can monitor and configure the IOLAN.
zNormal—The Normal level user has limited access to the IOLAN. Limited CLI commands and Menu access are available with the ability to configure the user’s own configuration settings.
zRestricted—The Restricted level user can only access predefined sessions or access the Easy Port Access menu.
zMenu—The menu level user will only be able to access predefined session or access the Easy Port Access menu. The Easy Port Access allows the user to connect to the accessible line without disconnecting their initial connection to the IOLAN. Does not have any access to CLI commands.
password
The password the user will need to enter to login to the IOLAN. This case-sensitive field accepts a maximum of 16 characters.
line-access
Specifies the user access rights to each IOLAN device line. Options are:
zRead/Write—Users are given read and write access to the line.
zRead In—Users are given access to read only outbound data, data that is going from the IOLAN to the device.
The onoff option is only for 1-port models. You can disable line access in 2-port + models by specifying 0 (zero).
service
The type of service that the user will use.
sess-timer
The amount of time, in seconds, that the Session Timer will run. Use this timer to forcibly close a user’s session (connection). When the Session Timer expires, the IOLAN will end the connection. The default value is 0 (zero), meaning that the session timer will not expire (the session is open permanently, or until the user logs out). The maximum value is 4294967 seconds. The User Session Timer will override the Line Session Timer, with the exception of reverse Telnet sessions.
port
When the User Service is Telnet, this is the target port number. The default value will change based on the type of Service selected; the most common known port numbers are used as the default values.
