Perle Systems IOLINK-520 manual IOLINK-PRO & 520 Reference Manual A.7

Page 50

Event Logs

Starting BACP negotiation with <remote site alias>

Generated when the Bandwidth Allocation Control Protocol negotiation has been initiated with the remote site device associated with the stated remote site profile.

Starting BCP negotiation with <remote site alias>

Generated when the Bridging Control Protocol negotiation has been initiated with the remote site device associated with the stated remote site profile.

Starting CCP negotiation with <remote site alias>

Generated when the Compression Control Protocol negotiation has been initiated with the remote site device associated with the stated remote site profile.

Starting CMCP negotiation with <remote site alias>

Generated when the Connection Management Control Protocol negotiation has been initiated with the remote site device associated with the stated remote site profile.

Starting IPCP negotiation with <remote site alias>

Generated when the Internet Protocol Control Protocol negotiation has been initiated with the remote site device associated with the stated remote site profile.

Starting IPXCP negotiation with <remote site alias>

Generated when the Internet Packet Exchange Control Protocol negotiation has been initiated with the remote site device associated with the stated remote site profile.

Station address table has been filled

Generated when the station address table is filled. This event is not regenerated until the table size drops below 3/4 full and then fills again.

STP disabled

Generated when STP is disabled.

STP enabled

Generated when STP is enabled.

TFTP: stop putting filename to <IP address>

The bridge/router has sent the final data packet of a file (filename), but has timed out before receiving the final ACK. The session may or may not have succeeded in delivering the entire file.

TFTP: <IP address> finished getting filename

The bridge/router has sent the final packet of a file (filename) that a LAN device with IP address displayed was getting from the bridge/router.

TFTP: <IP address> finished putting filename

The bridge/router has ACK-ed the last packet of a file (filename) that a LAN device with IP address displayed was putting onto the bridge/router.

IOLINK-PRO & 520 Reference Manual — A.7

Image 50

Contents Reference Manual IOLINK-PRO & 520 Routers IP Routing and the IOLINK-PRO & 520 RoutersComplete IP Connection ARP-Address Resolution ProtocolProxy ARP IOLINK-PRO & 520 Reference Manua Time to live IP Header DetailsProtocol Header ChecksumUnreachable Icmp MessagesOptions RedirectPing Time and Mask serverRoute Tables Update MechanismRIP-Routing Information Protocol Network Layer Addressing vs. MAC Addressing IPX Routing and The IOLINK-PRO & 520 RoutersIPX Addressing IPX Address FormatOther IPX Header Information IPX HeaderSAP Broadcasts Service Advertisement ProtocolEstablishing an IPX Connection SAP Requests Server TypesRouting Information Protocol RIP/X OperationRIP/X Metrics Bridging and the IOLINK-PRO & 520 RoutersRIP/X Requests Initial Bridging Process Station Address LearningAging Timer Address PurgingFilled Address Table Aging ExceptionLink Compression Iolink Router Feature DefinitionsTelnet Introduction Point-to-Point WAN TopologiesBandwidth On Demand MultipointTime of Day Connect Application Isdn Single Active Link & Dual Active Link Disaster Recovery Backup LinkOperating Software Upgrades Call Establishment Methods Iolink PRO & 520 Isdn Connection ManagementWide Area Network Topologies Supported Isdn Connection Management Auto-Call Time-of-Day ConnectionsAddress Connect Manual CallConnection Process CombinationSuspension Process Idle TimerProtocol Awareness Interesting TrafficSession Keepalive Messages Termination ProcessSuspension of TCP/IP Sessions IP SpecificsIP Address Connect RIP-Routing Information ProtocolSuspension of IPX Sessions IPX SpecificsRIP/IPX and SAP/IPX IPX Serialization FramesLink Clocking Information Pinout InformationModule Identification ATL CSU/DSU Link Module Information Link Interfaces ReferenceConsole Pinouts CSU/DSU Module T1/E1 Module24 & RS232C Link Pinouts RS232 Link Pinouts11 & X.21 Link Pinouts DB15 Female DTE Direction Contact Circuits From NumberRS442 & RS530 Link Pinouts DB25 Female DTE Direction Contact Circuit From Number NameNumber Name Link PinoutsDB25 RS232 Null-Modem Cable Configuration 11 RS232 Null-Modem CableNull-Modem Cable Configuration 12 V.35 Null-Modem CableRS530 Null-Modem Cable Configuration 13 RS530 Null-Modem CableRS530 To RS449 Conversion Cable 14 RS530 to RS449 Conversion Cable11/X.21 Null-Modem Cable Configuration 15 V.11/X.21 Null-Modem CableWAN Link Control-Signal Operation Appendix a Event Logs Event logsEvent Logs IOLINK-PRO & 520 Reference Manual A.3 Event Logs IOLINK-PRO & 520 Reference Manual A.5 Event Logs IOLINK-PRO & 520 Reference Manual A.7 Event Logs Alarm Logs Event Logs IOLINK-PRO & 520 Reference Manual A.11 Event Logs IOLINK-PRO & 520 Reference Manual A.13 Event Logs IOLINK-PRO & 520 Reference Manual A.15 Event Logs IOLINK-PRO & 520 Reference Manual A.17 Event Logs IOLINK-PRO & 520 Reference Manual A.19 PPP Security Logs MAC Address Filtering SecurityProgrammable Filtering Security-Filter if DestinationSecurity-Filter if Source Security-Forward if Destination Security-Forward if Source Programmable Filtering Protocol Discrimination Pattern Filter OperatorsBridge Pattern Filtering Filter all IP Packets Protocol Type FieldInternet Protocol IP IP, and no moreFilter all IP without TCP traffic Transport Control Protocol / Internet Protocol TCP/IPFilter only TCP/IP Filter all except TCP/IPEthernet Broadcasting Bandwidth ConservationFilter all DEC Ethernet MulticastingEthernet Station Addresses General RestrictionsInternet Addresses Mask Combinations Mask would be 6-010203040506&12-0800&23-06 ExampleIP Router Pattern Filtering IPX Router Pattern FilteringPage Appendix C Frame Formats Octet Locations on an IP Routed TCP/IP Frame IOLINK-PRO & 520 Reference Manual C.3