Appendix C
Servicing Information
Opening of the case and changing of modules is only to be performed by qualified service personnel.
WARNING !
Always disconnect the power cord from the rear panel of the bridge/router.
The bridge/router case does not need to be opened to change LAN or WAN interface modules.
Opening the case
1)Remove power from the bridge/router and remove the other cabling.
2)Turn the bridge/router over and place it on a flat, cushioned surface.
3)Remove the six Phillips head screws that fasten the case together (4 across the front and 1 on each rear side).
4)Hold the two halves of the case together and turn the bridge/router
5)Lift off the top half of the case. The LEDs in the front panel of the bridge/router are connected to the main board by a short ribbon cable. When lifting the top half of the case off, the lid should be lifted from the back and hinged at the front. The lid will then fold completely over and lie top down.
76