Perle Systems 1700 manual Eir, Disabled

Applications

	EIR
	Location: Main
	ªConfiguration
	ª WAN Set up
	ª Remote Site Set-up
	ª Edit Remote Site
	ª Connection Set-up
	ª EIR
	The EIR value specifies the indicated data rate that may be available for this
	PVC. This value must be set to the same as the value provided by the
	Frame Relay network provider. When EIR = 0, no excess burst data is
	allowed to be transmitted. If EIR is non-zero, bursting is allowed. The only
	restriction is that CIR + EIR > 0.

Configuration: When changing the EIR option for this PVC, the PVC must be disabled and

Note then enabled before the new value will take effect.

The Bridge, IP, IPX, and Compression settings may now be configured within the Bridge, Parameters, IP Parameters, IPX Parameters, and CCP Parameters menus (note: compression over frame relay is only available if PPP encapsulation is enabled).

If either the Bridge portion or the IP or IPX router portion of the connection is not required, the appropriate Connection Protocol setting must be disabled within the appropriate sub-menu. For example; if an IPX only connection is to be established, the Bridging and IP parameters must be disabled so that the router does not negotiate the Bridge or IP Connection Protocols on the connection.

	Connection Protocol Setting
	Location: Main
	ªConfiguration
	ª WAN Set up
	ª Remote Site Set-up
	ª Edit Remote Site
	ª Protocol Set-up
	ª Bridge Parameters
	ª Bridge enabled
	ª disabled
	ª IP Parameters
	ª IP enabled
	ª disabled
	Disabling a particular connection protocol option will prevent the
	router from negotiating that Network Connection Protocol. Leaving all
	options enabled will result in a Bridge, IP router, and IPX router
	connection.

43