Perle Systems 1700 manual IPX Routing, Ethernet-II Frames, RAW 802.3 Frames, Ieee 802.2 Frames

Applications

The following steps must be performed on the router connected to LAN #2.

	IPX Routing Disabled
	Location: Main
	ªConfiguration
	ª IPX Routing Set-up
	ª IPX Routing
	Disabling IPX routing allows the IPX frame types to be modified.

Configuration: IPX Routing does not need to be disabled in order to change the defined

Note	network numbers on a PPP router.
	IPX Frame Types
	Location: Main
	ªConfiguration
	ª LAN Set-up
	ª LAN IPX Set-up
	ª Ethernet-II Frames
	ª RAW 802.3 Frames
	ª IEEE 802.2 Frames
	ª 802.2 SNAP Frames
	Define the IPX network number for the appropriate frame type. Note
	that IPX network numbers must be unique. If more than one frame
	type is to be used, each frame type must have a unique IPX network
	number. There must be no duplicate IPX network numbers within your
	entire IPX routed network they must all be unique. The IPX network
	numbers may be any value from 0 to FFFFFFFF HEX.
	IPX Routing Enabled
	Location: Main
	ªConfiguration
	ª IPX Routing Set-up
	ª IPX Routing
	IPX routing must be re-enabled to allow the router to operate as an
	IPX router with the newly defined IPX network numbers.
	All connected router IPX routers must have IPX routing enabled for
	IPX routing to take place between the LANs. When one of the routers
	on a network has IPX routing disabled, all of the router IPX routers will
	become bridges only for IPX frames.

22