Perle Systems 1700 manual Identify the Connectors, P1705, P1730

Page 9

Applications

Identify the Connectors

P1705

The P1705 may be ordered with a 10Base2, 10Base5, or 10BaseT LAN interface.

If this P1705 has an ISDN U or S/T Module, it must only be installed in the slot 1 (leftmost position when viewed from the rear of the unit). The slot 2 position may be unused and covered with a blank panel or may contain another type of module. If a second WAN module is installed, only one BRI channel will be available for use.

Figure 1-2 Rear View of the P1705 with ISDN interface

P1730

The P1730 is configured with a 10/100BaseT LAN and either one or two optional interface modules. The optional modules may be a second LAN (10 BaseT), a second LAN plus one WAN module, a single WAN module or two WAN modules.

Important: If a second LAN module is installed, it must be in the slot 1 (leftmost position when viewed from the rear of the unit) to operate. In addition, if only one optional interface module is installed, it must be in slot 1

Each interface may be changed by simply removing the existing module and installing a new module. Refer to Appendix D: Servicing Information for information on replacing modules.

Link 1 module

Link 2 module LAN/Console module

 

 

MDI-X MDI

 

 

10/100 BT LAN

CSU/DSU

RS-232/V.24

CONSOLE

LINE

 

 

Power connector

Figure 1 -3 Rear View of the P1730 with a single LAN connection and two WAN

modules

3

Image 9
Contents Bridge / Routers User And System Administration Guide Federal Communications Commission FCC Using This Manual Contents Introduction to Filtering Appendix D Interface Pinouts Select a Site Unpack the RouterLocation of the Reset Hole on Router Identify the Reset SwitchIdentify the Connectors P1705P1730 Make the Link Connections Connect to the ConsoleManaging the P1705 & P1730 Using the Menus Power Up the Bridge/RouterOption Name ConventionsPassword Login to Bridge/Router and Enter the Required Configuration56/64 kbps T1 or E1First channel As specifedNumber of channels ReservedIsdn U Isdn S/T PPP Isdn Mandatory ConfigurationOff Identify the Status LEDsTypical Applications & How to Configure Them Bridging and Routing Should You Bridge or Route? Networks Bridged across a WAN link BridgingIP Address / Size of Subnet Mask IP RoutingIP Addressing IP Subnets MasksDefining an IP Subnet Mask IP Static Route IP Default GatewayNovell Servers in Both Locations IPX RoutingIPX Routed Local Area Networks Servers on one side Novell Servers in One Location OnlyEthernet-II Frames IPX RoutingRAW 802.3 Frames Ieee 802.2 FramesNovell Server with Dual LANs IPX ForwardingSelect LAN1 or LAN2 PPP Overview PPP Link ConfigurationNumbered Links Link IP addressPeer IP address Unnumbered LinksMultilink Operation Basic Isdn Connections Basic WAN ConfigurationsSwitch Type Directory NumberSpid Console after a full reset Soft ResetPPP Isdn Manual Call Quick Connections IP Address / Subnet mask size Manual CallFrame Relay configuration Basic Frame Relay ConfigurationLink Speed Auto Learning the Frame Relay ConfigurationLMI Type Manual Configuration LMI TypePPP Enabled Quick Start Frame RelayIP Address / mask size Quick Start PPP Leased Line Connections Basic Leased Line ConfigurationBridge Connection Configure Remote Site Profiles Isdn Number Configure Remote Site Profiles for Isdn PPPEnabled ªConfiguration WAN Set up Remote Site Set-up Configure Remote Site Profile for Frame RelayRemote Site Alias DlciCIR Primary LinkEIR DisabledConfigure Remote Site Profiles for Leased Line PPP Site profile Schedule RecoveryConfigure Remote Site Profiles for PPPoE ªenabledLAN ªTCP mss value ª1452 ªPPPoE remote site alias ªISP provided usernameConfigure Dynamic Host Configuration Protocol Advanced FeaturesªServer ªIP Address / number of addressesIP address external DNS server IP address local DNS serverNetwork Address Translation and Port Translation Enter the private network IP address of each service offered11 Napt Configuration Configure PPP Security SecuritySecurity Level Incoming PAP Password Outgoing PAP PasswordIncoming Chap Secret Outgoing Chap Secret 13 Sample Firewall Application Configure FirewallInbound Enter ID# 1 for ISP remote siteID# 1 for ISP remote site FTP ServerDestination Mask Filter ID # Destination AddressSource Address Source MaskCompression Network Address TranslationFilters Bandwidth On Demand EnableLocation Main QOS Priority QueuingªPriority ªPriority List Number Simple Network Time Protocol Sntp ªenableªTime ªIP AddressMAC Address Filtering Introduction to FilteringNot Pattern FilteringPopular Filters NetBIOS &NetBEUI Windows For WorkgroupsBridge IP & Related TrafficIP Router NetBIOS over TCPBanyan Other interesting TCP PortsAppendix a Menu Trees Menu Tree Menu Tree Octet Locations on a Bridged TCP/IP Frame Appendix B Octet Locations on Ethernet FramesConfiguration Pages Octet Locations Octet Locations on a Bridged XNS Frame Opening the case Appendix C Servicing InformationIdentifying the Internal Components To Clear a Lost Password Changing LAN or WAN InterfacesSelecting MDI or MDI-X LAN Interface Processor settings for the Isdn Link Modules Installing the Isdn Link ModulesChanging the Termination Straps on the Isdn S/T Interface Connecting to the ISDN-U Link ModulePerforming a Software Upgrade PC used for Tftp transfers Router a Router B Router C Pinout Information Link Clocking InformationATL-CSU/DSU Link Module Information Switches DB25 Female DCE Console PinoutsDB25 Female DTE 24 & RS232C Link PinoutsDB15 Female DTE 11/X.21 Link PinoutsDB25 Female DTE RS442 & RS530 Link PinoutsDCE Link PinoutsFigure D-9 RS232 Null-Modem Cable RS232 Null-Modem Cable ConfigurationFigure D 10 V-35 Null-Modem Cable Null-Modem Cable ConfigurationFigure D-11 RS530 Null-Modem Cable RS530 Null-Modem Cable ConfigurationFigure D-12 RS530 to RS449 Conversion Cable RS530 To RS449 Conversion CableFigure D-13 V.11/X.21 Null-Modem Cable 11/X.21 Null-Modem Cable Configuration