4.5.9 Readings
After adding the Device Parameters, including the Command, clicking on the READINGS page allows you to monitor the response back from the serial device. You can access the setpoints by clicking on the numbers 1 to 8.
Figure 4.19 iServer READINGS Page (-C4EIT)
Auto Update - To change the time interval of the page refresh, enter the amount of seconds in the box. If you want to manually refresh the page, refresh your browser or click on Readings.
4.5.9.1 Readings - Device Setpoints
Wait 10 seconds for the readings to update prior to accessing the setpoints or the value will not be valid.
Setpt 1, 2 3 4 - This field is where you enter the setpoint values.
Figure 4.20 iServer DEVICE SETPOINTS Page
34