Multi-Tech Systems MT2834BLR, MT2834BR manual #F2

	Chapter 4 - Commands
VALUES:	n = 0 thru 2
DEFAULT:	#F2
DESCRIPTION:	#F0 means no fallback when on-line.
	#F1 means fallback from 33600 to 4800 bps when on-line
	(increments of 2400 bps).
	#F2 means fallback to 4800 bps from 33.6K bps/fall
	forward if line improves (increments of 2400 bps).
COMMAND:	&Fn
VALUES:	n = 0, 8 or 9
DEFAULT:	&F8
DESCRIPTION:	&F loads factory default values from ROM.
	&F8 reads factory default values when &F is issued.
	&F9 reads parameters stored in nonvolatile memory when
	&F is issued.
COMMAND:	$Fn
VALUES:	n = 0 or 1
DEFAULT:	$F1
DESCRIPTION:	$F0 means do not fall back to normal connect if CR
	received.
	$F1 means fall back to normal connect if CR received.
COMMAND:	$FCn
VALUES:	n = 0 or 1
DEFAULT:	$FC1
DESCRIPTION:	$FC0 means no transmit of 5 second 2100Hz signal.
	$FC1 transmits 5 second 2100Hz signal.
COMMAND:	&Gn
VALUES:	n = 0, 1 or 2
DEFAULT:	&G0
DESCRIPTION:	&G0 turns off CCITT guard tones.
	&G1 turns on CCITT 550 Hz guard tone.
	&G2 turns on CCITT 1800 Hz guard tone (not used on
	International models).
COMMAND:	Hn
VALUES:	n = 0 or 1
DEFAULT:	n/a
DESCRIPTION:	H0 selects Hang Up (go on hook).
	H1 selects Go Off Hook.
COMMAND:	$Hn

36