4.2.1.2 "UPS status" zone: Essential information
◗"Active sources": (available on parallel or modular UPS)
xUPS + y UPS redundant : x indicates the minimal number of UPS necessary to power the load,
yindicates the number of UPS in redundancy.
An alarm can be generated if the number of UPS in redundancy is less than a configurable threshold. See UPS modules section.
◗"Power source": indicates whether the power comes from the utility or from the UPS battery
◗"Output load level": indicates the power percentage used at UPS output
◗"Output": indicates if the different UPS outputs are protected.
◗"Master": indicates if the UPS main output is protected
◗"Group1 and Group2": indicates if the controlled outlets (if available) are powered.
The various icons showing the status of the UPS outputs are:
(green outlet) | Outlet powered | |
| ||
|
| |
(red outlet) | Outlet not powered or not | |
protected | ||
| ||
|
|
Battery Information :
◗"Battery load level": remaining battery charge (in percent). The information is completed with the two following labels:
◗“Charging” : if the utility power is present and th e battery charge is in progress
◗“Discharging”: if the UPS operates on battery.
◗“Fault”: if the battery is faulty.
◗"Remaining backup time": Estimation of the battery's maximum backup time remaining before UPS shutdown
◗"Battery status": Result of the last automatic battery test carried out by the UPS Possible values are:
–OK: the test was completed correctly
–NOK: the battery needs to be checked
–Deactivated: the automatic battery test is not va lidated on the UPS
ENERGIZE YOUR ENTERPRISE |
|
|
Network Management Card – User Manual | 34003991EN/DA | Page 27/120 |