The BREAK command allows the sys admin to disconnect a user from the device port to which they were connected if they are in monitor, listen, or direct mode. The user is still logged in after the connection is broken, but there is no longer any connection between the terminal port and the device port. The sys admin must specify the terminal port number (as listed with the CONNECTIONS command) of the connection to be severed when using the BREAK command. Pressing <ENTER> or typing NO at the confirmation prompt will abort the command. To execute the command, enter YES at the confirmation prompt.
6.9.2FORCELOGOUT Command
sys admin>>FORCELOGOUT 1
Force this user off? (write out YES) Yes or No: No>yes
sys admin>>
The FORCELOGOUT command causes the forcible logout of a user at any level of connection. The user will be returned to the LCI3200> prompt after being forced off, and may login again unless their allowed logins are reduced to 0 before they can attempt another login. When using the FORCELOGOUT command, the sys admin must specify the terminal port number (as listed with the CONNECTIONS command) of the user to be forced off. Pressing <ENTER> or typing NO at the confirmation prompt will abort the command. To execute the command, enter YES at the confirmation prompt.
sys admin>>FORCELOGOUT SYSADMIN B
Force logout sys admin? (write out YES) Yes or No: No>yes
sys admin>>
The FORCELOGOUT command may also be used to disconnect a network sys admin session. The qualifiers SYSADMIN and the network card slot ID must be specified after the command.
6.9.3TELNETTIMEOUT Command
sys admin>>TELNETTIMEOUT Timeout set to 5 minutes
Sys admin>>TELNETTIMEOUT 0 Timeout set to 0 minutes
0 disables the timeout from occurring
sys admin>>TELNETTIMEOUT 2 Timeout set to 2 minutes
sys admin>>
39