Lightwave Communications 3200 user manual Listening to a Server Session

not have permission to access a server, the ConsoleServer 3200 will display the message NO ACCESS TO DEVICE CHANNEL, and the connection will not be made.

The user may exit from their current device port first by using the EXIT command or selecting EXIT FROM SERVER from the pull-down menu to free the device port for use by other users. A user may not select a server that is already selected by another user. When a server has been selected, the prompt will change to show which server has been selected by displaying the user ID, a dash, and then the server name in the general form USER_NAME-SERVER_NAME>. For example, if the user GEORGE selects Alpha, the prompt would read GEORGE-Alpha>.

When this prompt is displayed, the user is in monitor mode. There is no direct communication between the user and the server. Any output from the server is saved to a buffer that may be accessed by the user (see Section 7.11, Using the Buffer), but the user may issue no commands to the server. If the user desires to issue commands to the server, they must enter direct mode (see Section 7.10, Direct Mode).

Note that when selecting a server from a pull-down menu, only those device ports that are installed shall be displayed.

7.9Listening to a Server Session

F2 PULL-DOWN MENU TO LISTEN TO A DEVICE PORT PART 1

┌──────────────────────────┐

│ LOGGED IN MENU │

├──────────────────────────┤

│	CONNECT TO SERVER	│
│	DIR CONNECT TO SERVER	│
│	LISTEN TO SERVER	│
│	DISPLAY CONNECTED LIST	│
│	DISPLAY SERVER NAMES	│
│	DISPLAY ACTIVE DEVICES	│
│	LOGOUT	│
│	CHANGE PASSWORD	│
│	CHANGE DIRECT MODE ESC	│
│	CHANGE BREAK MODE ESC	│
│	DISPLAY HELP	│

└──────────────────────────┘

50