Lightwave Communications 3200 Serial terminal will display the following text at power-up

The serial terminal will display the following text at power-up:

ConsoleServer3200 Boot V1.76

Copyright 2000 by Lightwave Communications, Inc. All rights reserved. Identify Flash

Flash ID OK

Verifying Flash Image Starting system

Lightwave Communications, Inc. ConsoleServer3200 Please wait...system initializing

Checking non-volatile memory...

2048

Start checking and reading stored data Reading User Start up .........

LCI3200>>

The power-on self-test may be skipped by pressing <ESC> <ESC> or <CTRL>+C, but the ConsoleServer 3200 should be allowed to complete the POST if possible (this check usually takes about three minutes). This information is not available on a network connection, as it is not possible to connect to the ConsoleServer via telnet until the power-on self-test is complete. At the completion of the power-up sequence, the administrator is logged out, as indicated by the LCI3200>> prompt. Some commands may be used from this prompt, but most are available only when logged in.

NOTE: The administrator may define the system prompt using the PROMPT command (see section 6.11), but the system default prompt (LCI3200>>) is used in this manual for clarity.

6.1.1 Logging In, Serial Connection

LCI3200>>login

Please enter password: ****

sys admin>>

To log in on the ConsoleServer through a local serial connection, type LOGIN at the LCI3200>> prompt. The system returns the prompt Please enter password:. The default administrator password is PASS (see section 6.1.5 to change the administrator password). The ConsoleServer will only echo stars when the password is entered. If the password is correct, the prompt will change to sys admin>>.

17