Lantronix LX6 manual Figured, Link config-etherneteth0 level commands

	5: Commands and Levels
protocol tunnel	Applies tunnel protocol on the line.
reassert	Asserts line status with current configured values.
show	Displays the current status.
show command mode	Shows the command mode settings for the current line.
show history	Displays the last 20 commands entered during the current
	CLI session.
show line	Displays the current configuration.
show statistics	Shows the line statistics.
state disable	Disables the line so data cannot be sent/received.
state enable	Enables the line so data can be sent/received.
stop bits 1	Uses one stop bit after data on the line.
stop bits 2	Uses two stop bits after data on the line.
terminal <line>	Enters the configure-terminal level.
	<line> = number of the terminal line (serial port) to be
	configured.
terminal network	Enters the configure-terminal level for the network.
termination disable	Refrains from terminating the line.
termination enable	Enables 120 ohm line termination in RS485 half-duplex
	mode.
threshold <bytes>	Sets the threshold in bytes. After this many bytes are re-
	ceived, they are
	forwarded without delay.
tunnel <line>	Enters the tunnel level.
	<line> = number of the tunnel line (serial port) to be con-
	figured.
write	Stores the current configuration in permanent memory.
xoff char <control>	Sets the xoff character for use with software flow control
	on this line.
	The character may be input as text, control, decimal, or
	hex.
	A control character has the form <control>C.
	A decimal value character has the form \99.
	A hex value character has the form 0xFF.
xon char <control>	Sets the xon character for use with software flow control
	on this line.
	The character may be input as text, control, decimal, or
	hex.
	A control character has the form <control>C.
	A decimal value character has the form \99.
	A hex value character has the form 0xFF.
link (config-ethernet:eth0) level commands
clrscrn	Clears the screen.
default duplex	Restores the default duplex setting, which is auto.
default speed	Restores the default speed setting, which is auto-
	negotiate.
duplex auto	Sets duplex mode to auto.
duplex full	Sets duplex mode to full.
duplex half	Sets duplex mode to half.
exit	Exit back to interface configuration level
show	Displays the current configuration.

XPort® Pro Lx6 Embedded Device Server Command Reference 79