
|
| 5: Commands and Levels |
|
|
|
response type text | Uses text type responses. | |
show | Displays the current configuration. | |
show history | Displays the last 20 commands entered during the current | |
|
| CLI session. |
show status | Displays tunnel modem status. | |
verbose response disable | Does not send Modem Response Codes. | |
verbose response enable | Sends Modem Response Codes out on the Serial Line. | |
write | Stores the current configuration in permanent memory. | |
packing |
| |
clrscrn | Clears the screen. | |
default packing mode | Sets to default packing mode, which is "Disable" | |
default send character | Removes the send character for packing mode. | |
default threshold | Restores the default threshold. | |
default timeout | Restores the default packing mode timeout. | |
exit | Returns to the tunnel level. | |
no trailing character | Removes the trailing character for packing mode. | |
packing mode disable | Disables packing. Data is sent to the network when re- | |
|
| ceived. |
packing mode send character | Sets packing mode to accumulate data and transmit it | |
|
| upon receiving the |
|
| configured send character on the line (serial port). |
packing mode timeout | Sets packing mode to accumulate data and transmit it | |
|
| after a specified |
|
| amount of time (timeout). |
send character <control> | Sets the send character for packing mode. | |
|
| The character may be input as text, control, decimal, or |
|
| hex. |
|
| A control character has the form <control>C. |
|
| A decimal value character has the form \99. |
|
| A hex value character has the form 0xFF. |
show | Displays the current configuration. | |
show history | Displays the last 20 commands entered during the current | |
|
| CLI session. |
threshold <bytes> | Sets the threshold (byte count). If the queued data reach- | |
|
| es this threshold |
|
| then the data will be sent. |
|
| <bytes> = number of bytes in the threshold. |
timeout <milliseconds> | Sets the timeout value for packing mode in milliseconds. | |
|
| <milliseconds> = timeout value, in milliseconds. |
trailing character <control> | Sets the trailing character for packing mode. | |
|
| The character may be input as text, control, decimal, or |
|
| hex. |
|
| A control character has the form <control>C. |
|
| A decimal value character has the form \99. |
|
| A hex value character has the form 0xFF. |
write | Stores the current configuration in permanent memory. | |
password |
| |
clrscrn |
| Clears the screen. |
exit |
| Exits to the next higher level. |
no password |
| Removes the password so connections will be accepted |
XPort® Pro Lx6 Embedded Device Server Command Reference | 81 |