Lantronix EDS-MD16, EDS-MD8, EDS-MD4 manual Tunnel Settings, To Configure Tunnel Serial Settings

6: Line and Tunnel Settings

Using the CLI

To view Line statistics: enable -> line 1, show statistics

Using XML

Include in your file: <statusgroup name=”line” instance=”1”>

Tunnel Settings

Tunneling allows serial devices to communicate over a network, without “being aware” of the devices which establish the network connection between them. Tunneling parameters are configured using the Tunnel menu and submenus.The Tunnel settings allow you to configure how the Serial-Network tunneling operates. Tunneling is available on all serial Lines. The connections on one serial Line are separate from those on another serial port.

Note: The following section describes the steps to view and configure Tunnel 1 settings; these steps apply to other tunnel instances of the device.

Serial Settings

These serial settings for the tunnel apply to the Serial Line interface. The Line Settings and Protocol are displayed for informational purposes and must be configured from the Line settings.

	Table 6-3 Tunnel Serial Settings
Tunnel Serial	Description
Settings
Line Settings	Line Settings information here is display only. Go to the section, To Configure
	Line Settings to modify these settings.
Protocol	Protocol information here is display only. Go to the section, To Configure
	Line Settings to modify these settings.
DTR	Select the conditions in which the Data Terminal Ready (DTR) control signal
	on the Serial Line are asserted. Choices are:
	 Unasserted
	 TruPort = the DTR is asserted whenever either a connect or an accept
	mode tunnel connection is active with the Telnet Protocol RFC2217 saying
	that the remote DSR is asserted.
	 Asserted while connected = the DTR is asserted whenever either a
	connect or an accept mode tunnel connection is active.
	 Continuously asserted

To Configure Tunnel Serial Settings

Using Web Manager

To configure the Serial Settings for a specific tunnel, click Tunnel in the menu and select Tunnel 1 -> Serial Settings.

EDS-MD User Guide 37