|
| 6: Line and Tunnel Settings |
|
| Table |
|
|
|
| Line Command | Description |
| Mode Settings |
|
| Mode | Set the Command Mode state of the Line. When in Command Mode, a CLI session |
|
| operates exclusively on the Line. Choices are: |
|
| Always |
|
| User Serial String |
|
| Disabled |
|
| Note: In order to enable Command Mode on the Line, Tunneling on the Line must |
|
| be Disabled (both Connect and Accept modes). Also, custom baud rates are not |
|
| supported in Command Mode. |
|
|
|
| Wait Time | Enter the amount of time to wait during boot time for the Serial String. This timer |
|
| starts right after the Signon Message has been set on the Serial Line and applies |
|
| only if mode is “Use Serial String”. |
|
|
|
| Serial String | Enter the Text or Binary string of bytes that must be read on the Serial Line during |
|
| boot time in order to enable Command Mode. It may contain a time element to |
|
| specify a required delay in milliseconds x, formed as {x}. Applies only if mode is |
|
| “User Serial String”. It may contain a binary character(s) of the form [x]. For |
|
| example, use decimal [12] or hex [0xc]. |
|
|
|
| Echo Serial String | Select Enable or Disable for Echo Serial String. Applies only if mode is “User Serial |
|
| String”. Select enable to echo received characters backed out on the line while |
|
| looking for the serial string. |
|
|
|
| Signon Message | Enter the string of bytes to be sent to the Serial Line during boot time. It may contain |
|
| a binary character(s) of the form [x]. For example, use decimal [12] or hex [0xc]. |
|
|
|
To Configure Line Settings
Note: The following section describes the steps to view and configure Line 1 settings; these steps apply to other line instances of the device.
Using Web Manager
To configure a specific line, click Line in the menu and select Line 1
To configure a specific line in Command Mode, click Line in the menu and select Line 1
Using the CLI
To enter Line 1 command level: enable
Using XML
Include in your file: <configgroup name="line" instance="1">
Include in your file: <configgroup name="serial command mode" instance="1">
To View Line Statistics
Using Web Manager
To view statistics for a specific line, click Line in the menu and select Line 1
| 36 |