LevelOne WBR-1400TX manual Connections WBR-1100TX

Introduction

Connections - WBR-1100TX

	Figure 2: Connections - WBR-1100TX
Printer Port	A standard parallel printer port is on the side panel. If you wish to
	share a printer, connect it here.
Serial (RS232)	A standard RS232 Serial Port is on the side panel. If you have an
Port	analog modem or ISDN TA, connect it here.
WAN port	Connect the DSL or Cable Modem here. If your modem came with a
(10BaseT)	cable, use the supplied cable. Otherwise, use a standard LAN cable.
DIP switches	Refer to the following table.
PC port	If connecting directly to your PC (no Hub) use this port and a stan-
(10/100BaseT)	dard LAN cable (RJ45 connectors).
	Use EITHER the PC port OR the Hub port, NOT both.
HUB port	Use a standard LAN cable (RJ45 connectors) to connect this port to a
(10/100BaseT)	10BaseT or 100BaseT hub.
	Use EITHER the PC port OR the Hub port, NOT both.
Reset Button	This button has three (3) functions:
	• Reboot. When pressed and released, the LevelOne Wireless
	Broadband Router will reboot (restart).
	• Diagnostic print-out. If held down for 3 seconds, a diagnostic
	print-out will be sent to the attached printer.
	• Ensure the printer is ready.
	• Both Print LEDs will flash simultaneously during the diag-
	nostic printing.
	• Clear All Data. This button can also be used to clear ALL data
	and restore ALL settings to the factory default values.

To Clear All Data and restore the factory default values:

1.Power Off.

2.Hold the Reset Button down while you Power On.

3.Keep holding the Reset Button for a few seconds, until the RED LED has flashed TWICE.

4.Release the Reset Button. The LevelOne Wireless Broadband Router is now using the factory default values.

7