LevelOne WBR-1400TX, WBR-1100TX manual Printing, To remove an existing printer port installation

LevelOne Wireless Broadband Router User Guide

switching other devices Off, and see if this helps. Any "noisy" devices should be shielded or relocated.

•RF Shielding

Your environment may tend to block transmission between the wireless stations. This will mean high access speed is only possible when close to the Access Point.

Printing

Problem 1: When I tried to install the Printing software for Peer-to-Peer printing, I received an error message and the installation was aborted..

Solution 1: This may be caused by an existing installation of the printer port software. Before attempting another installation:

•Remove the existing installation

•Restart your PC

To remove an existing printer port installation:

1.Open Start - Settings - Control Panel - Add/Remove Programs

2.Look for an entry with a name like "Shared Port", "Shared Printer Port", "Print Server Driver" or "Print Server Port".

3.Select this item, click "Add/Remove", and confirm the deletion.

Problem 2: I am using Windows 95, and the Printing software installed and ran, but when I selected a port on a LevelOne Wireless Broadband Router and clicked "Add", the printer was not installed.

Solution 2: Try installing the printer using the standard Windows tools, as follows:

1.Start the Add Printer Wizard.

2.Select Network Printer when prompted "How is the printer attached to your Computer?", and click Next.

3.When prompted for the Network Path or Queue, enter a dummy value such as \\123, as shown below. (Do NOT select Yes for "Do you print for MS-DOS programs?")

4.The printer wizard will display a message stating that “The Network Printer is off-line”. This is OK. Continue the Add Printer Wizard until

92